enow.com Web Search

  1. Ad

    related to: notching 6x6 post for beam

Search results

  1. Results from the WOW.Com Content Network
  2. Log house - Wikipedia

    en.wikipedia.org/wiki/Log_house

    Similar to post-and-plank above: Uses short logs (e.g. 8' long) lying horizontally between upright posts, resembling post-and-beam construction (but usually lacking the complex notching seen with post-and-beam). Pièce en pièce typically uses a large (8"x 8") vertical corner post. It is important that a vertical component (often 3"x 6") be ...

  3. Post (structural) - Wikipedia

    en.wikipedia.org/wiki/Post_(structural)

    Crown – A post on a tie beam or collar beam carrying a crown plate. [26] Crown strut: A piece similar to a crown post but not carrying a plate. [27] Ashlar – or ashlar piece: Short post from a tie beam to a rafter near a masonry wall. [28] Purlin – A post supporting a purlin plate, may be plumb or leaning (canted).

  4. Mortise and tenon - Wikipedia

    en.wikipedia.org/wiki/Mortise_and_tenon

    Teasel (or teazle) tenon: a term used for the tenon on top of a jowled or gunstock post, which is typically received by the mortise in the underside of a tie beam. A common element of the English tying joint. Top tenon: the tenon that occurs on top of a post.

  5. Notching - Wikipedia

    en.wikipedia.org/wiki/Notching

    End notching works the end of the tube, such as a semicircular concavity to make the base of a tee, or a convex vee to fit into a mitre. Vee-notched tube, bent for assembly of a mitred joint. Side notching (also called offset notching) works the side of a tube with a vee notch for bending, semicircular or vee notches for tee joint.

  6. Parallel-strand lumber - Wikipedia

    en.wikipedia.org/wiki/Parallel-strand_lumber

    The beams are continuously formed, so the length of the beam is limited only to the maximum length that can be handled and transported. Typical widths are 3 + 1 ⁄ 2, 5 + 1 ⁄ 4 or 7 inches (89, 133 or 178 mm); typical depths are 9 + 1 ⁄ 2, 11 + 7 ⁄ 8, 14, 16 and 18 inches (240, 300, 360, 410 and 460 mm). Typically the beams are made to a ...

  7. Timber framing - Wikipedia

    en.wikipedia.org/wiki/Timber_framing

    The dragon-beam which runs diagonally from one corner to another, and supports the corner posts above and supported by the corner posts below; The jetty beams or joists conform t floor dimensions above, but are at right angles to the jetty-plates that conform to the shorter dimensions of "roof" of the floor below. Jetty beams are mortised at 45 ...

  8. Multiservice tactical brevity code - Wikipedia

    en.wikipedia.org/wiki/Multiservice_tactical...

    Notch All-aspect missile defensive maneuver to place threat radar/missile on the beam (directly perpendicular). Modern pulse-doppler radars remove ground clutter by filtering out returns from stationary objects; putting the threat on the beam permits the defending aircraft to be confused with ground returns and hence disappear from the threat ...

  9. King post - Wikipedia

    en.wikipedia.org/wiki/King_post

    The king post is the central, vertical member of the truss. Crown posts in the nave roof at Old Romney church, Kent, England. A king post (or king-post or kingpost) is a central vertical post used in architectural or bridge designs, working in tension to support a beam below from a truss apex above (whereas a crown post, though visually similar, supports items above from the beam below).

  1. Ad

    related to: notching 6x6 post for beam