Search results
Results from the WOW.Com Content Network
Cable management is particularly important in powered equipment which must move large distances while tethered to a power source and control cabling. There are several common methods of cable management. With a suspended sliding coil, the cables are coiled like a spring, with each loop of the coil attached to a sliding shoe on a track.
USB 1.0, 1.1, and 2.0 use two wires for power (V BUS and GND) and two wires for one differential signal of serial data. [7] Mini and micro connectors have their GND connections moved from pin #4 to pin #5, while their pin #4 serves as an ID pin for the On-The-Go host/client identification. [8]
Full speed (FS) rate of 12 Mbit/s is the basic USB signaling rate defined by USB 1.0. All USB hubs can operate at this rate. High speed (HS) rate of 480 Mbit/s was introduced in 2001 by USB 2.0. High-speed devices must also be capable of falling-back to full-speed as well, making high-speed devices backward compatible with USB 1.1 hosts ...
USB OTG defines two roles for devices: OTG A-device and OTG B-device, specifying which side supplies power to the link, and which initially is the host. The OTG A-device is a power supplier, and an OTG B-device is a power consumer. In the default link configuration, the A-device acts as a USB host with the B-device acting as a USB peripheral.
The ATI Twin Wonder TV tuner card. A TV tuner card is a kind of television tuner that allows television signals to be received by a computer. Most TV tuners also function as video capture cards, allowing them to record television programs onto a hard disk much like the digital video recorder (DVR) does. A DVB-S2 tuner card D-Link external TV tuner
It did not allow for extension cables, due to timing and power limitations. Few USB devices made it to the market until USB 1.1 was released in August 1998. USB 1.1 was the earliest revision that was widely adopted and led to what Microsoft designated the "Legacy-free PC". [22] [23] [24]
Reflections cause several undesirable effects, including modifying frequency responses, causing overload power in transmitters and overvoltages on power lines. However, the reflection phenomenon can be useful in such devices as stubs and impedance transformers. The special cases of open circuit and short circuit lines are of particular ...
In an electric power system, overcurrent or excess current is a situation where a larger than intended electric current exists through a conductor, leading to excessive generation of heat, and the risk of fire or damage to equipment.