Search results
Results from the WOW.Com Content Network
Murphy oil pressure gauges with switches that activate on low pressure. Oil pressure is an important factor in the longevity of most internal combustion engines. [1] With a forced lubrication system (invented by Frederick Lanchester), oil is picked up by a positive displacement oil pump and forced through oil galleries (passageways) into bearings, such as the main bearings, big end bearings ...
A Cylinder Head Temperature Gauge has a much shorter response time than the oil temperature gauge, so it can alert the pilot to a developing cooling issue more quickly. Engine overheating may be caused by: Running too long at a high power setting. Poor leaning technique. Restricting the volume of cooling airflow too much.
Also, to free up power, some engines in performance applications run lower weight oil, which requires less power to run the oil pump. Common oil weights in engines today are usually either 5W-30 or 10W-30 oil, whereas performance engines might use 0W-20 oil, which is less viscous.
Hydraulic pressure switches have various uses in automobiles, for example, to warn if the engine's oil pressure falls below a safe level, or to control automatic transmission torque converter lock-up. Prior to the 1960s, a pressure switch was used in the hydraulic braking circuit to control power to the brake lights; more recent automobiles use ...
On the oil output side of the wastegate actuator sits the density controller, an air-controlled oil valve which senses upper deck pressure and controls how fast oil can bleed from the wastegate actuator back to the engine. As the aircraft climbs and the air density drops, the density controller slowly closes the valve and traps more oil in the ...
The battery's charged state is maintained by an automotive alternator or (previously) a generator which uses engine power to create electrical energy storage. The battery supplies electrical power for starting when the engine has a starting motor system, and supplies electrical power when the engine is off. The battery also supplies electrical ...
These engines were designed to have a total-loss lubrication system, with the motor oil held in a separate tank from the fuel in the vehicle, and not pre-mixed with it as with two-cycle engines, but mixed within the engine instead while running. Castor oil was often used because it lubricates well at the high temperatures found in air-cooled ...
Aerated oil protects engine components far less effectively. A dry-sump system minimizes oil aeration, and also de-aerates oil far more effectively by pumping it first into a remote reservoir. Increased engine power. In a wet-sump engine, oil slosh against spinning parts causes substantial viscous drag which creates parasitic power loss.