Search results
Results from the WOW.Com Content Network
The USB Power Delivery specification revision 2.0 (USB PD Rev. 2.0) has been released as part of the USB 3.1 suite. [ 58 ] [ 65 ] [ 66 ] It covers the USB-C cable and connector with a separate configuration channel, which now hosts a DC coupled low-frequency BMC -coded data channel that reduces the possibilities for RF interference . [ 67 ]
12 V and 24 V powered USB sockets, on an NCR cash register. PoweredUSB, also known as Retail USB, USB PlusPower, USB +Power, and USB Power Plus, [1] is an addition to the Universal Serial Bus standard that allows for higher-power devices to obtain power through their USB host instead of requiring an independent power supply or external AC adapter.
USB 3.2, released in September 2017, [39] preserves existing USB 3.1 SuperSpeed and SuperSpeedPlus architectures and protocols and their respective operation modes, but introduces two additional SuperSpeedPlus operation modes (USB 3.2 Gen 1×2 and USB 3.2 Gen 2×2) with the new USB-C Fabric with signaling rates of 10 and 20 Gbit/s (raw data ...
The idle line state is when the device is connected to the host with a pull-up on either D+ (for full speed USB 1.x) or D− (for low speed USB 1.x), with transmitter output on both host and device is set to high impedance (hi-Z) (disconnected output). A USB device pulls one of the data lines high with a 1.5 kΩ resistor.
Modern high-powered graphics processing units do the same thing, resulting in most of the power requirement of a modern personal computer being on the +12 V rail. When high-powered GPUs were first introduced, typical ATX power supplies were "5 V-heavy", and could only supply 50–60% of their output in the form of 12 V power.
One of the two switches must be active (e.g., a transistor), while the other can be a diode. Sometimes, the topology can be changed simply by re-labeling the connections. A 12 V input, 5 V output buck converter can be converted to a 7 V input, −5 V output buck–boost by grounding the output and taking the output from the ground pin.
Quick Charge is a proprietary technology that can charge battery-powered devices, primarily mobile phones, at power levels exceeding the 7.5 watts (5 volts at 1.5 amps) supported by the USB BC 1.2 standard, using existing USB cables. The higher voltage available allows more power (watts) to be supplied through wires without excessive heating.
Additional to the traditional screw contacts the electrical connection between the module and other parts of the power electronic system can also be achieved by pin contacts (soldered onto a PCB), press-fit contacts pressed into PCB vias, spring contacts that inherently press on contact areas of a PCB or by pure pressure contact where corrosion-proof surface areas are directly pressed together ...