Search results
Results from the WOW.Com Content Network
The conversion of conductivity (in μS/cm) to the total dissolved solids (in mg/kg) depends on the chemical composition of the sample and can vary between 0.54 and 0.96. Typically, the conversion is done assuming that the solid is sodium chloride; 1 μS/cm is then equivalent to about 0.64 mg of NaCl per kg of water.
If this convention is used, then the values are in the same range as monovalent ions, e.g. 59.5 S cm 2 mol −1 for 1 / 2 Ca 2+ and 80.0 S cm 2 mol −1 for 1 / 2 SO 2− 4. [4] From the ionic molar conductivities of cations and anions, effective ionic radii can be calculated using the concept of Stokes radius.
(mol/s)/(m 2 ·mol/m 3) = m/s Note, the units will vary based upon which units the driving force is expressed in. The driving force shown here as ' Δ c A {\displaystyle {\Delta c_{A}}} ' is expressed in units of moles per unit of volume, but in some cases the driving force is represented by other measures of concentration with different units.
= 0.514 77 3 m/s mach number: M: Ratio of the speed to the speed of sound [note 1] in the medium (unitless). ≈ 340 m/s in air at sea level ≈ 295 m/s in air at jet altitudes metre per second (SI unit) m/s ≡ 1 m/s = 1 m/s mile per hour: mph ≡ 1 mi/h = 0.447 04 m/s: mile per minute: mpm ≡ 1 mi/min = 26.8224 m/s: mile per second: mps ≡ ...
where A and B are reactants C is a product a, b, and c are stoichiometric coefficients,. the reaction rate is often found to have the form: = [] [] Here is the reaction rate constant that depends on temperature, and [A] and [B] are the molar concentrations of substances A and B in moles per unit volume of solution, assuming the reaction is taking place throughout the volume of the ...
The CGS unit is the poise (P, or g·cm −1 ·s −1 = 0.1 Pa·s), [28] named after Jean Léonard Marie Poiseuille. It is commonly expressed, particularly in ASTM standards, as centipoise (cP). The centipoise is convenient because the viscosity of water at 20 °C is about 1 cP, and one centipoise is equal to the SI millipascal second (mPa·s).
A centimetre of water [1] is a unit of pressure. It may be defined as the pressure exerted by a column of water of 1 cm in height at 4 °C (temperature of maximum density) at the standard acceleration of gravity, so that 1 cmH 2 O (4°C) = 999.9720 kg/m 3 × 9.80665 m/s 2 × 1 cm = 98.063754138 Pa ≈ 98.0638 Pa, but conventionally a nominal maximum water density of 1000 kg/m 3 is used, giving ...
As can be seen, when the dimensional units appearing in the numerator and denominator of the equation's right hand side are cancelled out, both sides of the equation have the same dimensional units. Dimensional analysis can be used as a tool to construct equations that relate non-associated physico-chemical properties.