Search results
Results from the WOW.Com Content Network
Meters which respond to true RMS rather than mean current are described as "true RMS". Typical hand-held Hall effect units can read currents as low as 200 mA, and units that can read down to 1 mA are available. The Columbia tong test ammeter (illustrated) is an example of the iron vane type, used for measuring large AC currents up to 1000 amperes.
The design of the saturable inductor current sensor is similar to that of a closed-loop Hall-effect current sensor; the only difference is that this method uses the saturable inductor instead of the Hall-effect sensor in the air gap. Saturable inductor current sensor is based on the detection of an inductance change. The saturable inductor is ...
Megger tester: Measures Resistance of an Winding of Motor or Generator And Measures Earthing's Resistance Microwave power meter: Measures power at microwave frequencies Multimeter: General purpose instrument measures voltage, current and resistance (and sometimes other quantities as well) Network analyzer: Measures network parameters Ohmmeter
An LCR meter is a type of electronic test equipment used to measure the inductance (L), capacitance (C), and resistance (R) of an electronic component. [1] In the simpler versions of this instrument the impedance was measured internally and converted for display to the corresponding capacitance or inductance value.
This is a current-loaded measurement, which simulates in-use battery loads; normal voltage ranges draw very little current from the battery. Various sensors can be attached to (or included in) multimeters to take measurements such as: Luminance; Sound pressure level; pH; Relative humidity; Very small current flow (down to nanoamps with some ...
Electronic test equipment is used to create signals and capture responses from electronic devices under test (DUTs). In this way, the proper operation of the DUT can be proven or faults in the device can be traced. Use of electronic test equipment is essential to any serious work on electronics systems.
Ideally the measuring device should not affect the circuit parameters i.e., the internal impedance of the ammeter should be zero (no voltage drop over the ammeter) and the internal impedance of the voltmeter should be infinite (no current through the voltmeter). However, in actual case, ammeters have a low but non zero impedance and voltmeters ...
A receptacle tester being used to check for some types of improper wiring of an outlet. For this particular tester, proper wiring is indicated by the two yellow lights. The outlet tester checks that each contact in the outlet appears to be connected to the correct wire in the building's electrical wiring. It can identify several common wiring ...