Search results
Results from the WOW.Com Content Network
Wire diameter can be as small as 20 μm (0.79 mils) and the geometry precision is not far from ± 1 μm (0.039 mils). The wire-cut process uses water as its dielectric fluid, controlling its resistivity and other electrical properties with filters and PID controlled de-ionizer units. The water flushes the cut debris away from the cutting zone.
The spark gaps are placed as close as possible together for maximum UV light exchange for minimum jitter. DC HV comes from underneath, pulsed HV leaves at the top into the coaxial line. The double line of spheres in the middle are the spark gaps, all other spheres are to avoid corona discharge. Blue=water capacitor. Grey=solid metal. Black ...
Certain 1981–83 models used the EEC-III system, which uses a Dura-Spark III module (brown grommet where wires emerge) and a Dura-Spark II ignition coil. A resistance wire is used in the primary circuit. The distributors in EEC-III (and later) systems eliminate conventional mechanical and vacuum advance mechanisms. All timing is controlled by ...
Four spark plug wires (distributor end on the right, spark plug end on the left) Spark plug wires (also called high tension leads) are electrical cables used by older internal combustion engines to transmit high-voltage electricity from the distributor to the spark plugs. Tension in this instance is a synonym for voltage. High tension may also ...
Two factors considered in classifying a voltage as high voltage are the possibility of causing a spark in air, and the danger of electric shock by contact or proximity. The International Electrotechnical Commission and its national counterparts ( IET , IEEE , VDE , etc.) define high voltage as above 1000 V for alternating current , and at least ...
Based in Houston, the Houston-Galveston Area Council is a member of the Texas Association of Regional Councils. Its service area is 12,500 square miles and contains more than 6 million people in Southeast Texas. H-GAC is the regional organization through which local governments consider issues and cooperate in solving area-wide problems.
These tubes were made for home storage battery receivers manufactured during the early to mid-1930s; all have 2.0 volt DC filaments despite the 1-prefix, intended to distinguish them from the 2.5 volt AC heated tubes listed below 1A4-p – Remote-cutoff pentode; 1A4-t – Remote-cutoff tetrode
A power module or power electronic module provides the physical containment for several power components, usually power semiconductor devices. These power semiconductors (so-called dies ) are typically soldered or sintered on a power electronic substrate that carries the power semiconductors, provides electrical and thermal contact and ...