enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. North American Fire Hose Coupler Incompatibilities - Wikipedia

   en.wikipedia.org/wiki/North_American_Fire_Hose...

   1-inch hose with 1-8 NH NFPA threads (NFPA 1963 requirement; a.k.a. "Chemical Hose Thread" and "Booster Hose Thread" [7]; the chemical hose thread term likely originates from its use on chemical fire engines, an early firefighting device used from 1872 until the 1930s that used a combination of bicarbonate of soda and sulfuric acid to force ...

3. Preferred metric sizes - Wikipedia

   en.wikipedia.org/wiki/Preferred_metric_sizes

   ISO 1307:2006, Rubber and plastics hoses—Hose sizes, minimum and maximum inside diameters, and tolerances on cut-to-length hoses specifies nominal diameters for four different types of plastic hoses, including "Type C", which includes the typical garden hose. Each nominal diameter specifies different ID minimum and maximum values.

4. Hose coupling - Wikipedia

   en.wikipedia.org/wiki/Hose_coupling

   Hose link is a 1/4-turn bayonet-mount garden hose connection, which uses an o-ring to o-ring seal. It was designed by Hoselink, Pty, Ltd., Australia, [24] and patented in 1998. [25] It is popular in Australia, with limited distribution in the UK and the US, where it is distributed by Dayco Products, Inc.

5. National pipe thread - Wikipedia

   en.wikipedia.org/wiki/National_pipe_thread

   pipe size Thread density Thread pitch P Hand-tight engagement [6] Effective thread [6] Overall length L 4 [6] Actual outside diameter D Tap drill; Length L 1 Turns Diameter E 1 Length L 2 Turns Diameter E 2; inch inch −1 inch mm inch inch inch inch inch inch mm inch mm 1 ⁄ 16: 27 0.03703704 0.9407 0.1600: 4.32: 0.28118 0.2611: 7.05: 0.2875 ...

6. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   [21]: 149 Instead, pipe and fittings with plain (non-belled) connections are butted against each other, and clamped with special rubber sleeve (or "no-hub") fittings. [18]: 71 The rubber sleeves are typically secured with stainless steel worm drive clamping bands, which compress the rubber to make a tight seal around the pipes and fittings.

7. AN thread - Wikipedia

   en.wikipedia.org/wiki/AN_thread

   Note that AN threads are different for bolts and fittings. In bolts the number refers to the diameter of the bolt whereas in a fitting it refers to the OD of the tube and thereby have different threads. For example, AN6 bolt has a 3 ⁄ 8-24 thread [3] whereas an -6 AN fitting has a 9 ⁄ 16-18 thread. [4]