Search results
Results from the WOW.Com Content Network
The last is typically longer than the foot heel to toe length by 4 ⁄ 3 cm (13.33 mm) to 5 ⁄ 3 cm (16.67 mm), or 2 to 2 + 1 ⁄ 2 Paris points, so to determine the shoe size based on actual foot length one must add 2 Paris points. Because a Paris point is 2 ⁄ 3 of a centimetre, a centimetre is 3 ⁄ 2 Paris points, and the formula is as ...
The Egyptian equivalent of the foot—a measure of four palms or 16 digits—was known as the djeser and has been reconstructed as about 30 cm (11.8 in). The Greek foot (πούς, pous) had a length of 1 / 600 of a stadion, [12] one stadion being about 181.2 m (594 ft); [13] therefore a foot was, at the time, about 302 mm (11.9 in). Its ...
32.48 cm 1.066 ft Commonly abbreviated to pied, this corresponds to the foot, a traditional English unit. Known in English as the Paris foot (properly a separate, shorter unit), the royal foot, or French foot. toise: 6 1.949 m 6.394 ft, or 2.131 yd Six pieds du roi. This corresponds to the fathom, a traditional English unit. Unlike the fathom ...
In radio astronomy, the unit of electromagnetic flux is the jansky (symbol Jy), equivalent to 10 −26 watts per square metre per hertz (= 10 −26 kg/s 2 in base units, about 8.8×10 −31 BTU/ft 2). It is named after the pioneering radio astronomer Karl Jansky. The brightest natural radio sources have flux densities of the order of one to one ...
= 8.4 6 × 10 −5 m/s 2: foot per minute per second: fpm/s ≡ 1 ft/(min⋅s) = 5.08 × 10 −3 m/s 2: foot per second squared: fps 2: ≡ 1 ft/s 2 = 3.048 × 10 −1 m/s 2: gal; galileo: Gal ≡ 1 cm/s 2 = 10 −2 m/s 2: inch per minute per second: ipm/s ≡ 1 in/(min⋅s) = 4.2 3 × 10 −4 m/s 2: inch per second squared: ips 2: ≡ 1 in/s 2 ...
The stokes (St) is a unit of kinematic viscosity equal to 1 cm 2 ⋅s −1 (100 mm 2 ⋅s −1). [3] The stilb (sb) is a unit of luminance equal to 1 cd⋅cm −2 (10 kcd⋅m −2). [4] The phot (ph) is a unit of illuminance equal to 1 lm⋅cm −2 (10 klx). [3] The rayl is a unit of specific acoustic impedance, equal to 1 dyn⋅s⋅cm −3 (10 ...
[10] [11] [12]: 60–66 The system of Fournier was based on a different French foot of c. 298 mm. With the usual convention that 1 foot equals 12 inches, 1 inch (pouce) was divided into 12 lines (lignes) and 1 line was further divided into 6 typographic points (points typographiques). One Fournier point is about 0.0135 English inches.
The shaku had been standardized as 30.3 cm (11.93 in) since 1891. [5] This means that there are about 3.3 shaku (10 ⁄ 33) to one meter. [6] [7]This definition was established by Meiji government law; until then, even though the unit was given the same name, its length varied depending on the era.