Search results
Results from the WOW.Com Content Network
A rail repair dutchman is typically a 4–6-inch (100–150 mm) long piece of rail that is cut in advance for the purpose and carried by a section crew. If the gang finds a rail with a chipped or broken end, they remove the connector plates ( fishplates ), cut out the damaged section, replace it with the dutchman, and bolt the connectors back ...
Brushed stainless steel or dull polished metal [1] is metal with a unidirectional satin finish. It is produced by polishing the metal with a 120–180 grit belt or wheel then softening with an 80–120 grit greaseless compound or a medium non-woven abrasive belt or pad. Commonly brushed metals include stainless steel, aluminium and nickel.
Hemming and seaming are two similar metalworking processes in which a sheet metal edge is rolled over onto itself. Hemming is the process in which the edge is rolled flush to itself, while a seam joins the edges of two materials. [1] Hems are commonly used to reinforce an edge, hide burrs and rough edges, and improve appearance. [1]
The built up edge effectively changes tool geometry and rake steepness. It also reduces the contact area between the chip and the cutting tool, [1] leading to: A reduction in the power demand of the cutting operation. [1] Slight increase in tool life, since the cutting is partly being done by the built up edge rather than the tool itself. [4]
Metal burr extending beyond the edge of the cut piece, view on the cut face (top) and from the bottom (bottom) A burr is a raised edge or small piece of material that remains attached to a workpiece after a modification process. [1] It is usually an unwanted piece of material and is removed with a deburring tool in a process called deburring.
Sharpening these implements can be expressed as the creation of two intersecting planes which produce an edge that is sharp enough to cut through the target material. For example, the blade of a steel knife is ground to a bevel so that the two sides of the blade meet. This edge is then refined by honing until the blade is capable of cutting.
A space is drilled, into which a stone is inserted such that the girdle of the stone, the point of maximum diameter, is just below the surface of the metal. A burnishing tool is used to push metal all around the stone to hold the stone and give a flush appearance, with a burnished edge around it.
Tiler Terry Hallow works in the master bathroom, while the guys inspect the hardwood flooring and trim and stainless steel hardware. We then visit the Thames Barrier. New steel beams are fitted in the front wall, and only a few feet away, Jeremy looks at the recently installed kitchen.