Search results
Results from the WOW.Com Content Network
The hydraulic motor is the rotary counterpart of the hydraulic cylinder as a linear actuator. Most broadly, the category of devices called hydraulic motors has sometimes included those that run on hydropower (namely, water engines and water motors) but in today's terminology the name usually refers more specifically to motors that use hydraulic ...
Hull speed or displacement speed is the speed at which the wavelength of a vessel's bow wave is equal to the waterline length of the vessel. As boat speed increases from rest, the wavelength of the bow wave increases, and usually its crest-to-trough dimension (height) increases as well. When hull speed is exceeded, a vessel in displacement mode ...
Most boats have a positive PHRF rating, but some very fast boats have a negative PHRF rating. If Boat A has a PHRF rating of 15 and Boat B has a rating of 30 and they compete on a 1 mile course, Boat A should finish approximately 15 seconds in front of Boat B. Results are adjusted for handicap by the race committee after all competitors have ...
Some very long stroke engines have a maximum speed of around 80 rpm. The largest, most powerful engines in the world are slow speed, two stroke, crosshead diesels. Medium speed: any engine with a maximum operating speed in the range 300–1000 rpm. Many modern four-stroke medium speed diesel engines have a maximum operating speed of around 500 rpm.
Each boat's time is adjusted with the formula, and then the adjusted scores are compared to determine the outcome of the race. For example, a PD Racer (a semi-open homebuilt class, and the slowest listed boat in the USA scheme) has a D-PN of 140, and an A-Scow (the fastest listed centreboard boat) has a D-PN of 61.3. If an A Scow takes 1 hour ...
Boat prices vary depending on the model, make, size, features and condition. For instance, an 18- to 25-foot used pontoon can cost between $8,000 and $12,000 .
The useful power of an engine with shaft power output can be calculated using a dynamometer to measure torque and rotational speed, with maximum power reached when torque multiplied by rotational speed is a maximum. For jet engines the useful power is equal to the flight speed of the aircraft multiplied by the force, known as net thrust ...
The stall speed is defined as the highest speed at which the pump can turn when the output turbine is locked and full input torque (at the stall speed) is applied. Under stall conditions all of the engine's power at that speed would be dissipated in the fluid coupling as heat, possibly leading to damage.