Ads
related to: bolt tensile strength
Search results
Results from the WOW.Com Content Network
ASTM A325. ASTM A325 is an ASTM International standard for heavy hex structural bolts, titled Standard Specification for Structural Bolts, Steel, Heat Treated, 120/105 ksi Minimum Tensile Strength. It defines mechanical properties for bolts that range from ⁄ to 1⁄ inches (13 to 38 mm) in diameter. [1]
The ultimate tensile strength of a material is an intensive property; therefore its value does not depend on the size of the test specimen.However, depending on the material, it may be dependent on other factors, such as the preparation of the specimen, the presence or otherwise of surface defects, and the temperature of the test environment and material.
ASTM A490 and ASTM A490M are ASTM International standards for heavy hex structural bolts made from alloy steel.The imperial standard is officially titled Standard Specification for Structural Bolts, Alloy Steel, Heat Treated, 150 ksi Minimum Tensile Strength, while the metric standard (M) is titled Standard Specification for High-Strength Steel Bolts, Classes 10.9 and 10.9.3, for Structural ...
In structural and mechanical engineering, the shear strength of a component is important for designing the dimensions and materials to be used for the manufacture or construction of the component (e.g. beams, plates, or bolts). In a reinforced concrete beam, the main purpose of reinforcing bar (rebar) stirrups is to increase the shear strength.
Any tensile loads applied to these joints, usually have a secondary effect, but they can reduce available shear strength of the bolt. A clevis linkage, which relies on a locking mechanism (like lock washers, thread adhesives, and lock nuts), is a bearing type shear joint.
A bolt with property class 12.9 has a tensile strength of 1200 MPa (1 MPa = 1 N/mm 2) or 1.2 kN/mm 2 and the yield strength is 0.90 times tensile strength, 1080 MPa in this case. A bolt with property class 4.6 has a tensile strength of 400 MPa (1 MPa = 1 N/mm 2) or 0.4 kN/mm 2 and yield strength is 0.60 times tensile strength, 240 MPa in this case.
ASTM A354. ASTM A354 is an ASTM International standard that defines chemical and mechanical properties for alloy steel bolts, screws, studs, and other externally threaded fasteners. It is officially titled: Standard Specification for Quenched and Tempered Alloy Steel Bolts, Studs, and Other Externally Threaded Fasteners. [1]
Tensile testing, also known as tension testing, [1] is a fundamental materials science and engineering test in which a sample is subjected to a controlled tension until failure. Properties that are directly measured via a tensile test are ultimate tensile strength , breaking strength , maximum elongation and reduction in area. [ 2 ]
Ads
related to: bolt tensile strength