Search results
Results from the WOW.Com Content Network
Underground soft-rock mining is a group of underground mining techniques used to extract coal, oil shale, potash, and other minerals or geological materials from sedimentary ("soft") rocks. [1] Because deposits in sedimentary rocks are commonly layered and relatively less hard , the mining methods used differ from those used to mine deposits in ...
Mining of sulfur from a deposit at the edge of Ijen's crater lake, Indonesia. Mining is the extraction of valuable geological materials and minerals from the surface of the Earth. Mining is required to obtain most materials that cannot be grown through agricultural processes, or feasibly created artificially in a laboratory or factory.
Borehole mining tool and technology principle schematic. Borehole Mining (BHM) is a remote operated method of extraction (mining) of mineral resources through boreholes based on in-situ conversion of ores into a mobile form (slurry) by means of high pressure water jetting (hydraulicking). This process is carried-out from a land surface, open ...
Surface mining and deep underground mining are the two basic methods of mining. The choice of mining method depends primarily on depth, density, overburden, and thickness of the coal seam; seams relatively close to the surface, at depths less than approximately 55 m (180 ft), are usually surface mined. [citation needed]
Open-pit mining, also known as open-cast or open-cut mining and in larger contexts mega-mining, [1] is a surface mining technique that extracts rock or minerals from the earth. Open-pit mines are used when deposits of commercially useful ore or rocks are found near the surface where the overburden is relatively thin. In contrast, deeper mineral ...
Cut and fill mining is a method of short-hole mining used in steeply dipping or irregular ore zones, in particular where the hanging wall limits the use of long-hole methods. The ore is mined in horizontal or slightly inclined slices, and then filled with waste rock, sand or tailings. Either fill option may be cemented with binders to add ...
The act of mining requires different methods of extraction depending on the mineralogy, geology, and location of the resources. Characteristics such as mineral hardness, the mineral stratification, and access to that mineral will determine the method of extraction. Generally, mining is either done from the surface or underground.
Mining – extraction of valuable minerals or other geological materials from the earth, usually (but not always) from an ore body, vein or (coal) seam. Any material that cannot be grown from agricultural processes, or created artificially in a laboratory or factory , is usually mined.