Search results
Results from the WOW.Com Content Network
The VESA Enhanced Video Connector (EVC) is a VESA standard that was intended to reduce the number of cables around a computer by incorporating video, audio, FireWire and USB into a single cable system, terminating in a 35-pin Molex MicroCross connector. The intent was to make the monitor the central point of connection.
These connectors had the same number of pins as the above DE-15 connectors, but used the more traditional pin size, pin spacing, and size shell of the DA-15 standard connector. "VGA adapters" (i.e. DA-15 to DE-15 dongles) were available but sometimes monitor-specific, or they needed DIP switch configuration, as the Macintosh's monitor sense ...
Applies to V.35–V.39. V.35 is an ITU-T standard located on layer 1 on the OSI model. Max speed is 2 Mbit/s and synchronous only. Withdrawn ITU-T recommendation for 48 kbit/s data transmission over wideband circuits. The physical and electrical characteristics of this interface are now specified in ITU-T recommendation V.11.
USB 1.x/2.0 Mini/Micro pinout Pin Name Cable color Description 1 VBUS Red +5 V 2 D− White Data − 3 D+ Green Data + 4 ID None Permits distinction of host connection from slave connection
The VGA connector is a three-row, 15-pin D-subminiature connector referred to variously as DE-15, [2] HD-15 or commonly DB-15(HD). DE-15 is the accurate nomenclature under the proprietary D-sub specifications: an "E" size D-sub connector, with 15 pins in three rows.
XLR3 cable connectors, female on left and male on right. XLR connector plugs and sockets are used mostly in professional audio and video electronics cabling applications. XLR connector are also known as Cannon plugs after their original manufacturer. They are used for analog or digital balanced audio with a balanced line
The USB Type-C Cable and Connector Specification specifies a mapping from a USB-C jack to a 4-pole TRRS jack, for the use of headsets, and supports both CTIA and OMTP (YD/T 1885–2009) modes. [79] Some devices transparently handle many jack standards, [80] [81] and there are hardware implementations of this available as components. [82]
A separate connector is provided for DC power. [1] A 'universal' cable would have four drive connectors, two for each size of FDD, although cables which have only two drive connectors are common. The cable is normally a ribbon cable. For IBM-compatible floppy controllers, a twist in the cable reverses the order of conductors 10 through 16 for ...