Search results
Results from the WOW.Com Content Network
Barcol hardness is measured on a scale from 0 to 100 with the typical range being between 50B and 90B. A measurement of 60B is roughly equivalent to a Shore hardness of 80D or a Rockwell hardness M100. [4] [6] As defined in ASTM D 2583 the scale divisions from 0-100 should each indicate a depth of 0.0076 mm or the equivalent 0.0003 inches. [7]
A first-order estimate of the relation between ASTM D2240 type D hardness (for a conical indenter with a 15° half-cone angle) and the elastic modulus of the material being tested is [10] = (+ +), where is the ASTM D2240 type D hardness, and is in MPa.
The NLGI consistency number alone is not sufficient for specifying the grease required by a particular application. However, it complements other classifications (such as ASTM D4950 and ISO 6743-9). Besides consistency, other properties (such as structural and mechanical stability, apparent viscosity, resistance to oxidation, etc.) can be ...
ISO/ASTM FLOW CUP Flow Cups to BS EN ISO 2431, [4] ASTM D5125 Flow Cups to BS EN ISO 2431, ASTM D5125 Flow Cups to BS EN ISO 2431, ASTM D5125 Flow Cups to BS EN ISO 2431, ASTM D5125 Flow Cups to BS EN ISO 2431, ASTM D5125 The orifices are manufactured from stainless steel. 3mm (0.12”) 4mm (0.16”) 5mm (0.20”) 6mm (0.24”) 8mm (0.31”) 7 ...
To assign winter grades, the dynamic viscosity is measured at various cold temperatures, specified in J300, in units of mPa·s, or the equivalent older non-SI units, centipoise (abbreviated cP), using two test methods. They are the cold-cranking simulator (CCS, ASTM D5293) and the mini-rotary viscometer (pumping, ASTM D4684). Each temperature ...
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
Test methodology and equipment is defined in the ASTM International publications ASTM C131 for particle sizes smaller than 37 mm (1.5 inches) and ASTM C535 for sizes larger than 19 mm (3/4 of an inch); the overlapping range of 19 to 37 mm can be tested by either of two standards. [1] [2]
The salt spray test (or salt fog test) is a standardized and popular corrosion test method, used to check corrosion resistance of materials and surface coatings.Usually, the materials to be tested are metallic (although stone, ceramics, and polymers may also be tested) and finished with a surface coating which is intended to provide a degree of corrosion protection to the underlying metal.