Search results
Results from the WOW.Com Content Network
For example, a USB 2 PCIe host controller card that presents 4 USB "Standard A" connectors typically presents one 4-port EHCI and two 2-port OHCI controllers to system software. When a high-speed USB device is attached to any of the 4 connectors, the device is managed through one of the 4 root hub ports of the EHCI controller.
A USB and Firewire Host Controller Interface (UFHC) is a register-level interface that enables a host controller for USB or IEEE 1394 hardware to communicate with a host controller driver in software. The driver software is typically provided with an operating system of a personal computer, but may also be implemented by application-specific ...
A four-port "long cable" "external box" USB hub A four-port "compact design" USB hub: upstream and downstream ports shown. A USB hub is a device that expands a single Universal Serial Bus (USB) port into several so that there are more ports available to connect devices to a host system, similar to a power strip. All devices connected through a ...
The USB mass storage device class (also known as USB MSC or UMS) is a set of computing communications protocols, specifically a USB Device Class, defined by the USB Implementers Forum that makes a USB device accessible to a host computing device and enables file transfers between the host and the USB device. To a host, the USB device acts as an ...
USB 3.0 SuperSpeed – host controller (xHCI) hardware support, no software overhead for out-of-order commands; USB 2.0 High-speed – enables command queuing in USB 2.0 drives; Streams were added to the USB 3.0 SuperSpeed protocol for supporting UAS out-of-order completions USB 3.0 host controller (xHCI) provides hardware support for streams
A USB compound device contains an embedded USB hub and one or more non-removable USB devices. [1] It may or may not have exposed downstream ports. The internal USB hub may be a physical IC that connects to other ICs, or the hub and all functions may be implemented in software on a single IC (though it is more common to integrate them as a composite device in this case).
The two rows of holes (labelled #3) are test points used during the manufacture of this USB memory key. Testpoints on a printed circuit board (labelled E34, E35, E36, …) next to teardrop vias. A test point is a location within an electronic circuit that is used to monitor the state of the circuitry or inject test signals. [1]
Test drivers and test stubs are both instrumental in software testing, but they serve distinct roles within a test harness. Test drivers are typically an active component and control or call the system under test without further inputs after they are initialised, stubs on the other hand are usually passive components that only receive data and ...