Search results
Results from the WOW.Com Content Network
An instruction set architecture (ISA) is an abstract model of a computer, also referred to as computer architecture.A realization of an ISA is called an implementation.An ISA permits multiple implementations that may vary in performance, physical size, and monetary cost (among other things); because the ISA serves as the interface between software and hardware.
An addressing mode specifies how to calculate the effective memory address of an operand by using information held in registers and/or constants contained within a machine instruction or elsewhere. In computer programming, addressing modes are primarily of interest to those who write in assembly languages and to compiler writers.
In contrast to the PDP-11's 3-bit fields, the VAX-11's 4-bit sub-bytes resulted in 16 addressing modes (0–15). However, addressing modes 0–3 were "short immediate" for immediate data of 6 bits or less (the 2 low-order bits of the addressing mode being the 2 high-order bits of the immediate data, when prepended to the remaining 4 bits in ...
However, more typical, or frequent, "CISC" instructions merely combine a basic ALU operation, such as "add", with the access of one or more operands in memory (using addressing modes such as direct, indirect, indexed, etc.). Certain architectures may allow two or three operands (including the result) directly in memory or may be able to perform ...
[b] [c] Normally, an addressing mode without an index would simply use a bare ModR/M byte without a SIB byte at all, but this is necessary to encode an ESP-relative address ([ESP+disp0/8/32]). When MOD=00, a BASE of 101, which would specify EBP with zero displacement, instead specifies no base register and a 32-bit displacement.
MIPS I has instructions that load and store 8-bit bytes, 16-bit halfwords, and 32-bit words. Only one addressing mode is supported: base + displacement. Since MIPS I is a 32-bit architecture, loading quantities fewer than 32 bits requires the datum to be either sign-extended or zero-extended to 32 bits.
Before the RISC philosophy became prominent, many computer architects tried to bridge the so-called semantic gap, i.e., to design instruction sets that directly support high-level programming constructs such as procedure calls, loop control, and complex addressing modes, allowing data structure and array accesses to be combined into single instructions.
Postincrement and predecrement addressing modes are supported on all three. Y and Z also support a six-bit positive displacement. Instructions which allow an immediate value are limited to registers R16–R31 (8-bit operations) or to register pairs R25:R24–R31:R30 (16-bit operations ADIW and SBIW).