Ads
related to: 4gb ddr2 ram single module 1ebay.com has been visited by 1M+ users in the past month
cdw.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
DDR2 is a 240-pin module, DDR is a 184-pin module. Notebooks have 200-pin SO-DIMMs for DDR and DDR2; however, the notch on DDR2 modules is in a slightly different position than on DDR modules. Higher-speed DDR2 DIMMs can be mixed with lower-speed DDR2 DIMMs, although the memory controller will operate all DIMMs at same speed as the lowest-speed ...
A DIMM (Dual In-Line Memory Module) is a popular type of memory module used in computers. It is a printed circuit board with one or both sides (front and back) holding DRAM chips and pins . [ 1 ] The vast majority of DIMMs are manufactured in compliance with JEDEC memory standards , although there are proprietary DIMMs.
1 GB PC3200 non-ECC modules are usually made with 16 512 Mbit chips, 8 on each side (512 Mbits × 16 chips) / (8 bits (per byte)) = 1,024 MB. The individual chips making up a 1 GB memory module are usually organized as 2 26 8-bit words, commonly expressed as 64M×8. Memory manufactured in this way is low-density RAM and is usually compatible ...
A module built out of 100 MHz SDRAM chips is not necessarily capable of operating at 100 MHz. The PC100 standard specifies the capabilities of the memory module as a whole. PC100 is used in many older computers; PCs around the late 1990s were the most common computers with PC100 memory.
A SIMM (single in-line memory module) is a type of memory module used in computers from the early 1980s to the early 2000s. It is a printed circuit board on which has random-access memory attached to one or both sides. [ 1 ]
In computing, a memory module or RAM stick is a printed circuit board on which memory integrated circuits are mounted. [1] Memory modules permit easy installation and replacement in electronic systems, especially computers such as personal computers, workstations, and servers. The first memory modules were proprietary designs that were specific ...
Also some memory controllers have a maximum supported number of ranks. DRAM load on the command/address (CA) bus can be reduced by using registered memory. [citation needed] Predating the term rank (sometimes also called row) is the use of single-sided and double-sided modules, especially with SIMMs. While most often the number of sides used to ...
DDR3L single-channel or LPDDR3 dual-channel memory controller supporting up to 4 GB; ECC supported in single-channel mode Display controller with 2 MIPI DSI ports and 2 DDI ports (eDP 1.3, DP 1.1a, DVI, or HDMI 1.4a)
Ads
related to: 4gb ddr2 ram single module 1ebay.com has been visited by 1M+ users in the past month
cdw.com has been visited by 1M+ users in the past month