Search results
Results from the WOW.Com Content Network
In plumbing, a Fixture Unit (FU) or Drain Fixture Unit (DFU) is "a unit of measure, based on the rate of discharge, time of operation and frequency of use of a fixture, that expresses the hydraulic load imposed by that fixture on the sanitary plumbing installation". [1] A Fixture Unit is not a flow rate unit but a design factor.
Floor drain system in bathroom, Korea. A floor drain is a plumbing fixture that is installed in the floor of a structure, mainly designed to remove any standing water near it. They are usually round, but can also be square or rectangular. They usually range from 2 to 12 inches (5.1 to 30.5 cm); most are 4 inches (10 cm) in diameter.
Kitchen and bathroom faucets were limited to a flow rate of 2.2 gpm (gallons per minute) at 60 psi, and residential shower heads were limited to a flowrate of 2.5 gpm at 80 psi. [ 3 ] In response to an increasing number of water shortages and increased water utility rates there has been recent legislation by many states leading the way in water ...
Each of these plumbing fixtures has one or more water outlets and a drain. In some cases, the drain has a device that can be manipulated to block the drain to fill the basin of the fixture. Each fixture also has a flood rim, or level at which water will begin to overflow. Most fixtures also have an overflow, which is a conduit for water to ...
MDL – methane drainage licence (United Kingdom), a type of onshore licence allowing natural gas to be collected "in the course of operations for making and keeping safe mines whether or not disused" MDSS – measured depth referenced to mean sea level zero datum – "subsea" level
A trench drain (also known as a channel drain, line drain, slot drain, linear drain, or strip drain) is a specific type of floor drain featuring a trough- or channel-shaped body. It is designed for the rapid evacuation of surface water or for the containment of utility lines or chemical spills.
A drainage equation is an equation describing the relation between depth and spacing of parallel subsurface drains, depth of the watertable, depth and hydraulic conductivity of the soils. It is used in drainage design. Parameters in Hooghoudt's drainage equation. A well known steady-state drainage
Pool drain vortex as viewed from above the water at Grange Park wading pool Underwater view of drain, showing vortex-formation phenomenon. A drain is the primary vessel or conduit for unwanted water or waste liquids to flow away, either to a more useful area, funnelled into a receptacle, or run into sewers or stormwater mains as waste discharge to be released or processed.