Search results
Results from the WOW.Com Content Network
Some samples are full product samples, such as a brick or section of precast concrete, or a partial sample that indicates color or texture. [2] The product sample is often required when several products are acceptable, to confirm the quality and aesthetic level of the material. The size or unit of sample material usually is specified.
Some software solutions insert a grid on the 2D data sheets, so that the measured characteristics may be uniquely identified by the part number and the related revision number of the 2D data sheet, and the relative position of the characteristics on it (e.g.: in quarter A2, C10). [citation needed]
Sampling provides one rational means of verification that a production lot conforms with the requirements of technical specifications. 100% inspection does not guarantee 100% compliance and is too time-consuming and costly. Rather than evaluating all items, a specified sample is taken, inspected or tested, and a decision is made about accepting ...
An example SDS, including guidance for handling a hazardous substance and information on its composition and properties. A safety data sheet (SDS), [1] material safety data sheet (MSDS), or product safety data sheet (PSDS) is a document that lists information relating to occupational safety and health for the use of various substances and products.
Examples of these include: elevators, structural steel, trusses, pre-cast concrete, windows, appliances, cabinets, air handling units, and millwork. Also critical are the installation and coordination shop drawings of the MEP trades such as sheet metal ductwork, piping, plumbing, fire protection, and electrical.
The balance to finish is then calculated by subtracting the total completed to date from the original line item total. The Architect or Owner’s representative will then review and approve the amount due to the contractor during that pay period. A template that can be used for a typical SOV is the ConsensusDocs 293 - Schedule of Values. [2]
The divisions are subdivided into sections, each one addressing a specific material type (concrete) or a work product (steel door) of the construction work. A specific material may be covered in several locations, depending on the work result: stainless steel (for example) can be covered as a sheet material used in flashing and sheet Metal in ...
Geometrical Product Specification and Verification (GPS&V) [1] is a set of ISO standards developed by ISO Technical Committee 213. [2] The aim of those standards is to develop a common language to specify macro geometry (size, form, orientation, location) and micro-geometry (surface texture) of products or parts of products so that the language can be used consistently worldwide.