Search results
Results from the WOW.Com Content Network
The equation can only be applied when the purged volume of vapor or gas is replaced with "clean" air or gas. For example, the equation can be used to calculate the time required at a certain ventilation rate to reduce a high carbon monoxide concentration in a room.
Solvation or dissolution is a kinetic process and is quantified by its rate. Solubility quantifies the dynamic equilibrium state achieved when the rate of dissolution equals the rate of precipitation. The consideration of the units makes the distinction clearer. The typical unit for dissolution rate is mol/s.
A solubility equilibrium exists when a chemical compound in the solid state is in chemical equilibrium with a solution containing the compound. This type of equilibrium is an example of dynamic equilibrium in that some individual molecules migrate between the solid and solution phases such that the rates of dissolution and precipitation are equal to one another.
It is mostly shown in chemical equations by appending (aq) to the relevant chemical formula. For example, a solution of table salt, also known as sodium chloride (NaCl), in water would be represented as Na + (aq) + Cl − (aq). The word aqueous (which comes from aqua) means pertaining to, related to, similar to, or dissolved in, water.
The equilibrium state is represented by the equation: + + If α is the fraction of dissociated electrolyte, then αc 0 is the concentration of each ionic species. (1 - α) must, therefore be the fraction of undissociated electrolyte, and (1 - α)c 0 the concentration of same. The dissociation constant may therefore be given as
The solubility of a specific solute in a specific solvent is generally expressed as the concentration of a saturated solution of the two. [1] Any of the several ways of expressing concentration of solutions can be used, such as the mass, volume, or amount in moles of the solute for a specific mass, volume, or mole amount of the solvent or of the solution.
The integral heat of dissolution is defined as a process of obtaining a certain amount of solution with a final concentration. The enthalpy change in this process, normalized by the mole number of solute, is evaluated as the molar integral heat of dissolution. Mathematically, the molar integral heat of dissolution is denoted as
Solution polymerization is a method of industrial polymerization.In this procedure, a monomer is dissolved in a non-reactive solvent that contains a catalyst or initiator.. The reaction results in a polymer which is also soluble in the chosen solvent.