Search results
Results from the WOW.Com Content Network
For example, sulfuric acid (H 2 SO 4) is a diprotic acid. Since only 0.5 mol of H 2 SO 4 are needed to neutralize 1 mol of OH −, the equivalence factor is: f eq (H 2 SO 4) = 0.5. If the concentration of a sulfuric acid solution is c(H 2 SO 4) = 1 mol/L, then its normality is 2 N. It can also be called a "2 normal" solution.
Sulfuric acid is a colorless oily liquid, and has a vapor pressure of <0.001 mmHg at 25 °C and 1 mmHg at 145.8 °C, [16] and 98% sulfuric acid has a vapor pressure of <1 mmHg at 40 °C. [ 17 ] In the solid state, sulfuric acid is a molecular solid that forms monoclinic crystals with nearly trigonal lattice parameters.
In analytical chemistry, a solution of any substance which contains one equivalent per litre is known as a normal solution (abbreviated N), so the example sodium hydroxide solution would be 0.0893 N. [3] [13] The relative uncertainty (u r) in the measured concentration can be estimated by assuming a Gaussian distribution of the measurement ...
Molar concentration or molarity is most commonly expressed in units of moles of solute per litre of solution. [1] For use in broader applications, it is defined as amount of substance of solute per unit volume of solution, or per unit volume available to the species, represented by lowercase : [2]
A mixture of ammonia gas and water vapor is introduced into a reactor that contains a saturated solution of ammonium sulfate and about 2% to 4% of free sulfuric acid at 60 °C. Concentrated sulfuric acid is added to keep the solution acidic, and to retain its level of free acid. The heat of reaction keeps reactor temperature at 60 °C. Dry ...
A typical mixture is 3 parts of concentrated sulfuric acid and 1 part of 30 wt. % hydrogen peroxide solution; [1] other protocols may use a 4:1 or even 7:1 mixture. A closely related mixture, sometimes called "base piranha", is a 5:1:1 mixture of water, ammonia solution ( NH 4 OH , or NH 3 (aq) ), and 30% hydrogen peroxide.
For solutions of liquids or gases in liquids, the quantities of both substances may be given volume rather than mass or mole amount; such as litre of solute per litre of solvent, or litre of solute per litre of solution. The value may be given as a percentage, and the abbreviation "v/v" for "volume per volume" may be used to indicate this choice.
In 1908, John William Turrentine used a dilute ammonium persulfate solution to etch copper. Turrentine weighed copper spirals before placing the copper spirals into the ammonium persulfate solution for an hour. After an hour, the spirals were weighed again and the amount of copper dissolved by ammonium persulfate was recorded.