enow.com Web Search

  1. Ads

    related to: increase speed in ethernet

Search results

  1. Results from the WOW.Com Content Network
  2. Link aggregation - Wikipedia

    en.wikipedia.org/wiki/Link_aggregation

    In addition, there is a basic layer-3 aggregation [20] that allows servers with multiple IP interfaces on the same network to perform load balancing, and for home users with more than one internet connection, to increase connection speed by sharing the load on all interfaces. [21]

  3. Gigabit Ethernet - Wikipedia

    en.wikipedia.org/wiki/Gigabit_Ethernet

    Gigabit Ethernet was the next iteration, increasing the speed to 1000 Mbit/s. The initial standard for Gigabit Ethernet was produced by the IEEE in June 1998 as IEEE 802.3z, and required optical fiber. 802.3z is commonly referred to as

  4. 100 Gigabit Ethernet - Wikipedia

    en.wikipedia.org/wiki/100_Gigabit_Ethernet

    802.3ba is the designation given to the higher speed Ethernet task force which completed its work to modify the 802.3 standard to support speeds higher than 10 Gbit/s in 2010. The speeds chosen by 802.3ba were 40 and 100 Gbit/s to support both end-point and link aggregation needs respectively.

  5. Ethernet over twisted pair - Wikipedia

    en.wikipedia.org/wiki/Ethernet_over_twisted_pair

    Ethernet over twisted-pair technologies use twisted-pair cables for the physical layer of an Ethernet computer network. They are a subset of all Ethernet physical layers . Early Ethernet used various grades of coaxial cable , but in 1984, StarLAN showed the potential of simple unshielded twisted pair .

  6. Jumbo frame - Wikipedia

    en.wikipedia.org/wiki/Jumbo_frame

    Jumbo frames can increase the efficiency of Ethernet and network processing in hosts by reducing the protocol overhead, as shown in the following example with TCP over IPv4. The processing overhead of the hosts can potentially decrease by the ratio of the payload sizes (approximately six times improvement in this example). Whether this is ...

  7. Ethernet frame - Wikipedia

    en.wikipedia.org/wiki/Ethernet_frame

    The internal structure of an Ethernet frame is specified in IEEE 802.3. [2] The table below shows the complete Ethernet packet and the frame inside, as transmitted, for the payload size up to the MTU of 1500 octets. [b] Some implementations of Gigabit Ethernet and other higher-speed variants of Ethernet support larger frames, known as jumbo frames.

  1. Ads

    related to: increase speed in ethernet