Search results
Results from the WOW.Com Content Network
There are several types of Ethernet frames: Ethernet II frame, or Ethernet Version 2, [g] or DIX frame is the most common type in use today, as it is often used directly by the Internet Protocol. Novell raw IEEE 802.3 non-standard variation frame; IEEE 802.2 Logical Link Control (LLC) frame; IEEE 802.2 Subnetwork Access Protocol (SNAP) frame
End nodes utilizing a MAC layer will usually detect an oversized Ethernet frame and cease receiving. A bridge/switch will not forward the frame. [64] A non-uniform frame size configuration in the network using jumbo frames may be detected as jabber by end nodes. [citation needed] Jumbo frames are not part of the official IEEE 802.3 Ethernet ...
In computer networking, jumbo frames are Ethernet frames with more than 1500 bytes of payload, the limit set by the IEEE 802.3 standard. [1] The payload limit for jumbo frames is variable: while 9000 bytes is the most commonly used limit, smaller and larger limits exist.
A frame is a digital data transmission unit in computer networking and telecommunications. In packet switched systems, a frame is a simple container for a single network packet . In other telecommunications systems, a frame is a repeating structure supporting time-division multiplexing .
IEEE 802.1Q, often referred to as Dot1q, is the networking standard that supports virtual local area networking (VLANs) on an IEEE 802.3 Ethernet network. The standard defines a system of VLAN tagging for Ethernet frames and the accompanying procedures to be used by bridges and switches in handling such frames.
The original 2.94 Mbit/s Ethernet implementation had eight-bit addresses and other differences in frame format. [9] 10BASE5: 802.3-1985 (8) AUI, N, vampire tap: 500 m RG-8/U Original standard uses a single coaxial cable in which a connection is made by tapping into the single cable, drilling in to make contact with the core and the screen.
The IP MTU and Ethernet maximum frame size are configured separately. In Ethernet switch configuration, MTU may refer to Ethernet maximum frame size. In Ethernet-based routers, MTU normally refers to the IP MTU. If jumbo frames are allowed in a network, the IP MTU should also be adjusted upwards to take advantage of this.
10 Gigabit Ethernet (abbreviated 10GE, 10GbE, or 10 GigE) is a group of computer networking technologies for transmitting Ethernet frames at a rate of 10 gigabits per second. It was first defined by the IEEE 802.3ae-2002 standard.