Search results
Results from the WOW.Com Content Network
A variety of terms such as 'line-up level' and 'operating level' exist, and their meaning may vary from place to place. In an attempt bring clarity to level definitions in the context of programme transmission from one country to another, where different technical practices may apply, ITU-R Rec. BS.645 defined three reference levels: Measurement Level (ML), Alignment Level (AL) and Permitted ...
conversion combination output units SI: cubic metre: m3 m 3: US spelling: cubic meter one kilolitre 1.0 m 3 (35 cu ft) cubic centimetre: cm3 cm 3: US spelling: cubic centimeter one millilitre 1.0 cm 3 (0.061 cu in) cc cc cubic millimetre: mm3 mm 3: US spelling: cubic millimeter: 1.0 mm 3 (6.1 × 10 −5 cu in) non-SI metric: kilolitre: kl kl US ...
For example, the conversion factor between a mass fraction of 1 ppb and a mole fraction of 1 ppb is about 4.7 for the greenhouse gas CFC-11 in air (Molar mass of CFC-11 / Mean molar mass of air = 137.368 / 28.97 = 4.74). For volume fraction, the suffix "V" or "v" is sometimes appended to the parts-per notation (e.g. ppmV, ppbv, pptv).
Download as PDF; Printable version; In other projects ... Water chemists measure water impurities in parts per million (ppm). ... "CONVERSION FACTORS" (PDF ...
Download as PDF; Printable version; In other projects ... This article gives a list of conversion factors for several physical quantities. ... ≡ 240 mL [18] = 2.4 ...
where TDS is expressed in mg/L and EC is the electrical conductivity in microsiemens per centimeter at 25 °C. The conversion factor k e varies between 0.55 and 0.8. [5] Some TDS meters use an electrical conductivity measurement to the ppm using the above formula. Regarding units, 1 ppm indicates 1 mg of dissolved solids per 1,000 g of water. [6]
Standard cubic centimeters per minute (SCCM) is a unit used to quantify the flow rate of a fluid. 1 SCCM is identical to 1 cm³ STP /min. Another expression of it would be Nml/min. Another expression of it would be Nml/min.
The factor–label method can convert only unit quantities for which the units are in a linear relationship intersecting at 0 (ratio scale in Stevens's typology). Most conversions fit this paradigm. An example for which it cannot be used is the conversion between the Celsius scale and the Kelvin scale (or the Fahrenheit scale). Between degrees ...