Search results
Results from the WOW.Com Content Network
Unlike ATEX which uses numbers to define the safety "Category" of equipment (namely 1, 2, and 3), the IEC continued to utilise the method used for defining the safe levels of intrinsic safety namely "a" for zone 0, "b" for zone 1 and "c" for zone 2 and apply this Equipment Level of Protection to all equipment for use in hazardous areas since ...
This is a list of Superfund sites in Virginia designated under the Comprehensive Environmental Response, Compensation, and Liability Act (CERCLA) environmental law.The CERCLA federal law of 1980 authorized the United States Environmental Protection Agency (EPA) to create a list of polluted locations requiring a long-term response to clean up hazardous material contaminations. [1]
1. Industrial or Mining Application 2. Equipment Category 3. Atmosphere 4. Temperature The ATEX as an EU directive finds its US equivalent under the HAZLOC standard. This standard given by the Occupational Safety and Health Administration defines and classifies hazardous locations such as explosive atmospheres.
Intrinsic safety (IS) is a protection technique for safe operation of electrical equipment in hazardous areas by limiting the energy, electrical and thermal, available for ignition. In signal and control circuits that can operate with low currents and voltages, the intrinsic safety approach simplifies circuits and reduces installation cost over ...
Removing the use of a hazardous chemical is an example of elimination. [1] Some substances are difficult or impossible to eliminate because they have unique properties necessary to the process, but it may be possible to instead substitute less hazardous versions of the substance. [9] Elimination also applies to equipment as well.
The Hierarchy of Occupational Exposure Limits, of which occupational exposure banding is a member. Occupational exposure banding, also known as hazard banding, is a process intended to quickly and accurately assign chemicals into specific categories (bands), each corresponding to a range of exposure concentrations designed to protect worker health.
Maximum experimental safe gap (MESG) is a standardized measurement of how easily a gas flame will pass through a narrow gap bordered by heat-absorbing metal. MESG is used to classify flammable gases for the design and/or selection of electrical equipment in hazardous areas, and flame arrestor devices. [1]
The light curtain projects a field or beams of light between two points and, when the field is broken-at any point, the light curtain system interrupts the circuit it is wired into. These can be used in areas where an operator must interact with operating equipment to prevent movement of the equipment while the operator works a hazardous area.