Search results
Results from the WOW.Com Content Network
Face Veneer thickness-- For any three-ply construction, which applies to 3 and 4 mm material, each face veneer shall be not thinner than 1/8 of the total thickness of veneers assembled dry. Since the dry thicknesses of the boards are 3.6 and 4.6 respectively, we can assume that, for these thicknesses only, the face veneers will be as follows:
Medium density overlay panel, or MDO panel, is a paintable surface made of plywood with a weather-resistant resin overlay bonded to the wood by heat and pressure. The overlay, which has at least 27% resin content, [1] resists water, weather, wear and degradation. A similar product with a more rugged, smoother surface is called high density ...
The sizes of the most commonly used plywood sheets are 4 by 8 feet (1,220 mm × 2,440 mm) [20] which was first used by the Portland Manufacturing Company, who developed modern veneer core plywood for the 1905 Portland World Fair. A common metric size for a sheet of plywood is 1200 × 2400 mm. 5 × 5 feet (1,500 × 1,500 mm) is also a common ...
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
Plywood and OSB typically have a density of 560–640 kg/m 3 (35–40 lb/cu ft). For example, 9.5 mm (3 ⁄ 8 in) plywood sheathing or OSB sheathing typically has a surface density of 4.9–5.9 kg/m 2 (1–1.2 lb/sq ft). [51] Many other engineered woods have densities much higher than OSB.
The pressing cycle operates in stages, with the mat thickness being first compressed to around 1.5 times the finished board thickness, then compressed further in stages and held for a short period. This gives a board profile with zones of increased density, thus mechanical strength, near the two faces of the board and a less dense core.
A thickness planer is a woodworking machine to trim boards to a consistent thickness throughout their length and flat on both surfaces. It is different from a surface planer, or jointer, where the cutter head is set into the bed surface. A surface planer has slight advantages for producing the first flat surface and may be able to do so in a ...
The girth measurement should then be taken at the narrowest point below the odd growth and the height of the girth measurement noted. In some cases a girth taken just above the odd growth will be more representative of the actual girth of the tree. In these cases the measurement should be taken there and the height above the base of the tree noted.