enow.com Web Search

  1. Ads

    related to: which buffing pad to use for wax guards on metal roof tiles

Search results

  1. Results from the WOW.Com Content Network
  2. List of commercially available roofing materials - Wikipedia

    en.wikipedia.org/wiki/List_of_commercially...

    Standing-seam metal roof with concealed fasteners. Mechanically seamed metal with concealed fasteners contains sealant in seams for use on very low sloped roofs, suitable for roofs of low pitch such as 0.5/12 to 3/12 pitch. Flat-seam metal with or without soldered seams. Steel coated with a coloured alloy of zinc and aluminium. Stone-coated ...

  3. Surface finishing - Wikipedia

    en.wikipedia.org/wiki/Surface_finishing

    One takes great care to remove any surface defects in the metal, like pits, that could allow bacteria to grow. A #4 dairy or sanitary finish is produced by polishing with a 180–240 grit belt or wheel finish softened with 120–240 grit greaseless compound or a fine non woven abrasive belt or pad.

  4. Polishing (metalworking) - Wikipedia

    en.wikipedia.org/wiki/Polishing_(metalworking)

    The removal of oxidization (tarnish) from metal objects is accomplished using a metal polish or tarnish remover; this is also called polishing. To prevent further unwanted oxidization, polished metal surfaces may be coated with wax, oil, or lacquer. This is of particular concern for copper alloy products such as brass and bronze. [2]

  5. Metal roof - Wikipedia

    en.wikipedia.org/wiki/Metal_roof

    A metal roof is a roofing system featuring metal pieces or tiles exhibiting corrosion resistance, impermeability to water, and long life. It is a component of the building envelope . The metal pieces may be a covering on a structural, non-waterproof roof, or they could be self-supporting sheets.

  6. RoofTG - Wikipedia

    en.wikipedia.org/wiki/RoofTG

    The first coated metal roofing tiles to be made in New Zealand were produced by Martile Roofing Ltd in Howick in 1956 and were pressed from an aluminium manganese alloy. They were then coated with High Bake Enamel. By 1957, L.J. Fisher had bought the rights to use the Martile profile from A.L.W. Martinsen and Son Ltd and was producing his own tile.

  7. Flashing (weatherproofing) - Wikipedia

    en.wikipedia.org/wiki/Flashing_(weatherproofing)

    Shaped like a “U” or channel to catch water (e.g., where the edge of a tile roof meets a wall). Through wall flashing Spans the thickness of the wall and directs water to weep holes. Cap flashing (drip cap) Often used above windows and doors. Drip edge A metal used at the edges of a roof. Step flashing (soaker, base flashing)

  8. Rustproofing - Wikipedia

    en.wikipedia.org/wiki/Rustproofing

    The compounds are usually wax-based and can be applied by aerosol can, brush, low pressure pump up spray, or compressor fed spray gun. An alternative for sills/rocker panels is to block drain holes and simply fill them up with wax and then drain most of it out (the excess can be stored and reused), leaving a complete coating inside.

  9. Chemical-mechanical polishing - Wikipedia

    en.wikipedia.org/wiki/Chemical-mechanical_polishing

    The process uses an abrasive and corrosive chemical slurry (commonly a colloid) in conjunction with a polishing pad and retaining ring, typically of a greater diameter than the wafer. The pad and wafer are pressed together by a dynamic polishing head and held in place by a plastic retaining ring.

  1. Ads

    related to: which buffing pad to use for wax guards on metal roof tiles