Search results
Results from the WOW.Com Content Network
The reference values for a "normal" random glucose test in an average adult are 80–140mg/dl (4.4–7.8 mmol/l), between 140 and 200mg/dl (7.8–11.1 mmol/l) is considered pre-diabetes [citation needed], and ≥ 200 mg/dl is considered diabetes according to ADA guidelines [1] (you should visit your doctor or a clinic for additional tests however as a random glucose of > 160mg/dl does not ...
A level below 5.6 mmol/L (100 mg/dL) 10–16 hours without eating is normal. 5.6–6 mmol/L (100–109 mg/dL) may indicate prediabetes and oral glucose tolerance test (OGTT) should be offered to high-risk individuals (old people, those with high blood pressure etc.). 6.1–6.9 mmol/L (110–125 mg/dL) means OGTT should be offered even if other ...
To establish a reference range, the Clinical and Laboratory Standards Institute (CLSI) recommends testing at least 120 patient samples. In contrast, for the verification of a reference range, it is recommended to use a total of 40 samples, 20 from healthy men and 20 from healthy women, and the results should be compared to the published reference range.
Verification is intended to check that a product, service, or system meets a set of design specifications. [6] [7] In the development phase, verification procedures involve performing special tests to model or simulate a portion, or the entirety, of a product, service, or system, then performing a review or analysis of the modeling results.
The glucose tolerance test was first described in 1923 by Jerome W. Conn. [4]The test was based on the previous work in 1913 by A. T. B. Jacobson in determining that carbohydrate ingestion results in blood glucose fluctuations, [5] and the premise (named the Staub-Traugott Phenomenon after its first observers H. Staub in 1921 and K. Traugott in 1922) that a normal patient fed glucose will ...
The Turing test is an informal validation method that was developed by the English mathematician Alan Turing in the 1950s, which at its roots is a specialized form of face validation because humans can be seen as "experts" on being able to analyze how other humans will respond in a given situation. Specifically, this model is best suited for ...
An insulin tolerance test (ITT) is a medical diagnostic procedure during which insulin is injected into a patient's vein, after which blood glucose is measured at regular intervals. This procedure is performed to assess pituitary function, adrenal function, insulin sensitivity , [ 1 ] [ 2 ] and sometimes for other purposes.
This test, unlike the other tests, is measured as a percentage because the test measure the proportion of all the hemoglobin that has glucose attached. [2] [10] This test measures the average amount of diabetic control over a period of about 3 months. [10] In non-diabetic people, the HbA1c level ranges from 4.0 to 5.7%. [10]