Search results
Results from the WOW.Com Content Network
The temperature of the cooling air may range from well below freezing to 50 °C. Further, while engines in long-haul boat or rail service may operate at a steady load, road vehicles often see widely varying and quickly varying load. Thus, the cooling system is designed to vary cooling so the engine is neither too hot nor too cold.
Radiator caps for pressurized automotive cooling systems. Of the two valves, one prevents the creation of a vacuum, the other limits the pressure. It is generally a limitation of most cooling systems that the cooling fluid not be allowed to boil, as the need to handle gas in the flow greatly complicates design.
New cars produced in the early 1990s contained the new refrigerant in their air conditioning systems. Owners of older cars with R-12 systems would either have to invest in an R-12 to R-134a conversion system, buy a new car, or find a qualified technician to recharge their older R-12 system. R-134a has been used in cars for almost 30 years.
Pages in category "Automotive cooling systems" This category contains only the following page. This list may not reflect recent changes. A. Automotive air conditioning
Most modern internal combustion engines are cooled by a closed circuit carrying liquid coolant through channels in the engine block and cylinder head. A fluid in these channels absorbs heat and then flows to a heat exchanger or radiator where the coolant releases heat into the air (or raw water, in the case of marine engines).
When the engine is cool or even at normal operating temperature, the fan clutch partially disengages the engine's mechanically driven radiator cooling fan, generally located at the front of the water pump and driven by a belt and pulley connected to the engine's crankshaft. This saves power, since the engine does not have to fully drive the fan.
A representative pressure–volume diagram for a refrigeration cycle. Vapour-compression refrigeration or vapor-compression refrigeration system (VCRS), [1] in which the refrigerant undergoes phase changes, is one of the many refrigeration cycles and is the most widely used method for air conditioning of buildings and automobiles.
Oil cooling is the use of engine oil as a coolant, typically to remove surplus heat from an internal combustion engine. The hot engine transfers heat to the oil which then usually passes through a heat-exchanger , typically a type of radiator known as an oil cooler .