enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Poly(methyl methacrylate) - Wikipedia

   en.wikipedia.org/wiki/Poly(methyl_methacrylate)

   It has a density of 1.17–1.20 g/cm 3, [1] [16] which is approximately half that of glass, which is generally, depending on composition, 2.2–2.53 g/cm 3. [1] It also has good impact strength, higher than both glass and polystyrene, but significantly lower than polycarbonate and some engineered polymers.

3. Visqueen - Wikipedia

   en.wikipedia.org/wiki/Visqueen

   Visqueen is a brand of polyethylene plastic sheeting ... (0.004 to 0.01 in./0.1 to 0.25 mm) thick and is ... sheets of Visqueen are used during floods to ...

4. Plastic film - Wikipedia

   en.wikipedia.org/wiki/Plastic_film

   Plastic film is a thin continuous polymeric material. Thicker plastic material is often called a "sheet". Thicker plastic material is often called a "sheet". These thin plastic membranes are used to separate areas or volumes, to hold items, to act as barriers, or as printable surfaces.

5. Molded pulp - Wikipedia

   en.wikipedia.org/wiki/Molded_pulp

   These products usually have wall thicknesses of 1.5 to 6 mm (1/16" to 1/4") and are used primarily for support packaging applications. Thick-Wall is also commonly referred to as "Slush Molded." The surfaces are very rough on one side and moderately smooth on the opposite side.

6. Twinwall plastic - Wikipedia

   en.wikipedia.org/wiki/Twinwall_plastic

   Roofing sheets made from twinwall plastic are primarily 10mm thick, however, they are also available in greater thicknesses such a 16mm, 25mm and 35mm. Any thickness over 10mm would usually be called a Multiwall Plastic Sheet due to having multiple internal layers. Twinwall plastic can refer to several different extruded polymers including:

7. High-density polyethylene - Wikipedia

   en.wikipedia.org/wiki/High-density_polyethylene

   HDPE is known for its high strength-to-density ratio. [4] The density of HDPE ranges from 930 to 970 kg/m 3. [5] Although the density of HDPE is only marginally higher than that of low-density polyethylene, HDPE has little branching, giving it stronger intermolecular forces and tensile strength (38 MPa versus 21 MPa) than LDPE. [6]