Search results
Results from the WOW.Com Content Network
Why Use Gypsum Board Instead of Drywall? Gypsum board and drywall are one and the same. Gypsum board is simply a technical name given to a plaster-based wall finish that helps in creating light walls.
The chief differences are that spackling paste typically dries faster, shrinks less during drying, and is meant for smaller repairs, and not for a whole room or house. It is not uncommon for the general public to call any of these products "spackle", but tradespersons usually specify joint compound (drywall mud) when that is specifically meant.
Typically, drywall is surfaced using the "mud-and-tape" method, where non-adhesive paper or mesh tape and drywall joint compound ("mud") is used to fill joints, cover nail heads, and repair any flaws. Plaster veneer was developed as a way of taking advantage of the reduced labor of modern drywall, while providing a genuine plaster surface for a ...
Various sized cuts of 1 ⁄ 2 in (13 mm) drywall with tools for maintenance and installation . Drywall (also called plasterboard, dry lining, [1] wallboard, sheet rock, gib board, gypsum board, buster board, turtles board, slap board, custard board, gypsum panel and gyprock) is a panel made of calcium sulfate dihydrate (), with or without additives, typically extruded between thick sheets of ...
This effort has, however, had little or no effect on the usage of the term in society at large, and has no effect at all on the definition of "drywall construction," a technical definition which involves the placement of gypsum panels on a substrate without the use of plaster as a finish material (per the latest USG technical manual, noted below).
In use as early as 1900, rock lath (also known as "button board," "plaster board" or "gypsum-board lath"), is a type of gypsum wall board (essentially an early form of drywall) with holes spaced regularly to provide a 'key' for wet plaster. [3] Rock lath was typically produced in sheets sized 2 by 4 feet (610 by 1,220 mm).
A gypsum block is made of gypsum plaster and water. The manufacturing process [1] is automated at production plants where raw gypsum (CaSO 4 ·2H 2 O) is ground and dried, then heated to remove three-quarters of the bound water and thus transformed into calcium sulfate hemihydrate (CaSO 4 ·½H 2 O), also known as gypsum plaster, stucco, calcined gypsum or plaster of Paris.
Plaster was first used as a building material and for decoration in the Middle East at least 7,000 years ago. In Egypt, gypsum was burned in open fires, crushed into powder, and mixed with water to create plaster, used as a mortar between the blocks of pyramids and to provide a smooth wall facing.