enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Lifting beam - Wikipedia

   en.wikipedia.org/wiki/Lifting_beam

   Rigging of an asymmetrical scaffolding piece: the lifting beam is blue, the load is attached to the beam using grey slings. The lifting beam (also known as traverse, spreader beam) is a steel beam that is attached to the hook of the crane in order to spread the slings from one end of an elongated load (like a wall panel) to another.

3. Lewis (lifting appliance) - Wikipedia

   en.wikipedia.org/wiki/Lewis_(lifting_appliance)

   It is made from three pieces of rectangular-section 13 mm (0.51 in)-thick steel legs held together with a shackle, allowing connection to a lifting hook. The middle leg is square throughout its length, while the outer legs are thinner at the top, flaring towards the bottom. Held together, the three legs thus form a dovetail shape.

4. Lifting hook - Wikipedia

   en.wikipedia.org/wiki/Lifting_hook

   A lifting hook with a safety latch. A lifting hook is a device for grabbing and lifting loads by means of a device such as a hoist or crane.A lifting hook is usually equipped with a safety latch to prevent the disengagement of the lifting wire rope sling, chain or rope to which the load is attached.

5. Riser clamp - Wikipedia

   en.wikipedia.org/wiki/Riser_clamp

   Riser clamp for a standpipe through-penetration firestop inside a fire hose cabinet under construction. A riser clamp is a type of hardware used by mechanical building trades for pipe support in vertical runs of piping (risers) at each floor level. The devices are placed around the pipe, and integral fasteners are then tightened to clamp them ...

6. Overhead crane - Wikipedia

   en.wikipedia.org/wiki/Overhead_crane

   Double Girder Overhead Crane. The double girder overhead crane structure is used for heavier applications up to 125 tons and reaching over 100 feet of span. It can also be used to gain lifting height because the hoist of the double girder overhead crane is placed on the beams and the hook fits between them. Suspended Overhead Crane

7. Crane (machine) - Wikipedia

   en.wikipedia.org/wiki/Crane_(machine)

   Hook: the hook is used to connect the material to the crane, suspended from the hoist rope either at the tip (on luffing jib cranes) or routed through the trolley (on hammerhead cranes). Weights : Large, moveable concrete counterweights are mounted toward the rear of the counterdeck, to compensate for the weight of the goods lifted and keep the ...