Search results
Results from the WOW.Com Content Network
The visible water surface in a toilet is the top of the trap's water seal. Each fixture drain, with exceptions, must be vented so that negative air pressure in the drain cannot siphon the trap dry, to prevent positive air pressure in the sewer from forcing gases past the water seal, and to prevent explosive sewer gas buildup.
Shop drawings are produced by contractors and suppliers under their contract with the owner. The shop drawing is the manufacturer’s or the contractor’s drawn version of information shown in the construction documents. [1] The shop drawing normally shows more detail than the construction documents.
A structural drawing, a type of engineering drawing, is a plan or set of plans and details for how a building or other structure will be built. Structural drawings are generally prepared by registered professional engineers, and based on information provided by architectural drawings. The structural drawings are primarily concerned with the ...
A drawing which based on the detailed drawing, installation drawing or co-ordination drawing (interface drawing) with the primary purpose of defining that information needed by the tradesmen on site to install the works or concurrently work among various engineering assembly. The main features of typical installation drawings are:
In plumbing, a closet flange (also known as a toilet flange) is a pipe fitting (specifically, a type of flange) that both mounts a toilet to the floor and connects the closet bend to a drain pipe. The name comes from the term "water closet", the traditional name for a toilet. Closet flanges are typically made of brass, cast iron, ABS, PVC, and ...
A flush toilet (also known as a flushing toilet, water closet (WC); see also toilet names) is a toilet that disposes of human waste (i.e., urine and feces) by collecting it in a bowl and then using the force of water to channel it ("flush" it) through a drainpipe to another location for treatment, either nearby or at a communal facility.
The textile block system is a unique structural building method created by Frank Lloyd Wright in the early 1920s. While the details changed over time, the basic concept involves patterned concrete blocks reinforced by steel rods, created by pouring concrete mixture into molds, thus enabling the repetition of form.
[citation needed] These restrictions might require multiple wiring cupboards on each floor of a large building. The inside of a wiring closet at a small public university. Visible are an optical fiber switch (top), a 66-type punch block (left), and two 110-type punch blocks (right, bottom). The orange conduit contains optical fiber cable.