Search results
Results from the WOW.Com Content Network
Port mirroring on a Cisco Systems switch is generally referred to as Switched Port Analyzer (SPAN) or Remote Switched Port Analyzer (RSPAN). Other vendors have different names for it, such as Roving Analysis Port (RAP) on 3Com switches. Network engineers or administrators use port mirroring to analyze and debug data or diagnose errors on a ...
Another method to monitor networks is to use port mirroring (called "SPAN", for Switched Port Analyzer, by vendors such as Cisco, [1] and given other names, such MLXe telemetry by Brocade Communications and other vendors)(also known as MIRROR port) or a monitoring protocol such as TZSP on routers and switches. This is a low-cost alternative to ...
A limitation of Port Aggregation Protocol is that all the physical ports in the aggregation group must reside on the same switch. Cisco's 6500 and the 4500E platforms, remove this limitation using Virtual Switching System (VSS), [1] which allows port channels to be split between two chassis. PAgP is not supported in Cisco Nexus Switches.
They deploy one or more network taps or enable switch SPAN ports for port mirroring to gain access to traffic. They deploy Zeek on servers with access to those visibility points. [ 10 ] The Zeek software on the server deciphers network traffic as logs, writing them to local disk or remote storage.
Through port mirroring, a switch can create a mirror image of data that can go to an external device, such as intrusion detection systems and packet sniffers. A modern switch may implement power over Ethernet (PoE), which avoids the need for attached devices, such as a VoIP phone or wireless access point, to have a separate power supply.
Cisco Inter-Switch Link (ISL) is a Cisco proprietary link layer protocol that maintains VLAN information in Ethernet frames as traffic flows between switches and routers, or switches and switches. [1] ISL is Cisco's VLAN encapsulation protocol and is supported only on some Cisco equipment over the Fast and Gigabit Ethernet links. It is offered ...
EtherChannel between a switch and a server. EtherChannel is a port link aggregation technology or port-channel architecture used primarily on Cisco switches.It allows grouping of several physical Ethernet links to create one logical Ethernet link for the purpose of providing fault-tolerance and high-speed links between switches, routers and servers.
The port will not send out DTP frames or be affected by any incoming DTP frames. If you want to set a trunk between two switches when DTP is disabled, you must manually configure trunking using the (switchport mode trunk) command on both sides. The configured switch port mode setting is referred to as the port's trunking administrative mode.