Search results
Results from the WOW.Com Content Network
Ozone for dental application In dentistry as and antimicrobial agent and therapies including implantology, oral surgery, periodontology, oral medicine and the treament of caries. Ozone is used mainly in private dental practices and is open to poor implementation as the mechanism of action is not well enough understood to routinely use. [37]
Most of the ozone production occurs in the tropical upper stratosphere and mesosphere. The total mass of ozone produced per day over the globe is about 400 million metric tons. The global mass of ozone is relatively constant at about 3 billion metric tons, meaning the Sun produces about 12% of the ozone layer each day. [1]
The chemical reaction is exothermic and the exterior temperature of the generator will reach 260 °C (500 °F). It will produce oxygen for 12 to 22 minutes. [2] [3] The two-mask generator is approximately 63 mm (2.5 in) in diameter and 223 mm (8.8 in) long. The three-mask generator is approximately 70 mm (2.8 in) in diameter and 250 mm (9.8 in ...
This is the most common type of ozone generator for most industrial and personal uses. While variations of the "hot spark" coronal discharge method of ozone production exist, including medical grade and industrial grade ozone generators, these units usually work by means of a corona discharge tube or ozone plate.
The term oxygen generator is a misnomer in that the oxygen is not generated as it is with a chemical oxygen generator, but rather it is concentrated from the air. Non-medical oxygen concentrators can be used as feed gas to a medical oxygen system, such as the oxygen system in a hospital, though governmental approval is required, such as by the ...
The work function of the electrons (the energy required to liberate the electrons from the surface) is considerably lower than the ionization energy of air at standard temperatures and pressures, making it a more liberal source of secondary electrons under these conditions. Again, the source of energy for the electron-liberation is a high ...
Fig. 1. The surface of a MEMS device is cleaned with bright, blue oxygen plasma in a plasma etcher to rid it of carbon contaminants. (100mTorr, 50W RF) Plasma cleaning is the removal of impurities and contaminants from surfaces through the use of an energetic plasma or dielectric barrier discharge (DBD) plasma created from gaseous species.
T-s diagram for the ideal/real ORC. The working principle of the organic Rankine cycle is the same as that of the Rankine cycle: the working fluid is pumped to a boiler where it is evaporated, passed through an expansion device (turbine, [3] screw, [4] scroll, [5] or other expander), and then through a condenser heat exchanger where it is finally re-condensed.