Search results
Results from the WOW.Com Content Network
The 30mm DS30M Mark 2 is a ship-protection system made by MSI-Defence Systems consisting of a 30mm Mark 44 Bushmaster II cannon on an automated mount. It was designed to defend Royal Navy frigates from fast inshore attack craft armed with short-range missiles, rocket-propelled grenades , machine guns , or explosives.
The Advanced Target Pointer Illuminator Aiming Laser, ATPIAL AN/PEQ-15 known colloquially as the "PEQ-15" [/ p ɛ k / / f ɪ f t iː n /] produced by L3Harris (originally designed and manufactured by Insight Technology, until their acquisition by L3Harris in 2010); is a multifunction IR Target Pointer & Illuminator, a.k.a. a Laser Aiming Module (LAM) for use as a rifle attachment, using a ...
A Leupold telescopic sight mounted on a dovetailed rifle receiver via two scope rings From left: A sketch of a cross section on a Zeiss rail and ring mount, both with a Picatinny rail interface. Scope mounts are rigid implements used to attach (typically) a telescopic sight or other types of optical sights onto a firearm .
The FN FAL from which the L1A1 Self-Loading Rifle was derived was not designed for mounting optical sights like the SUIT. To mount the SUIT, a new top cover was designed. This had a rail welded to the top to accept the sight mount, and two tabs at the rear of the pressed sheet steel cover which butted against the back of the upper receiver, preventing the cover from sliding on its rails and ...
The AN/PEQ-2 has two infrared laser emitters;one narrow beam used for aiming the rifle and one wide beam used for illuminating targets, like a flashlight. [9] The beams can only be seen through night vision goggles. [9] Each beam can be zeroed independently, and the illuminator's radius is adjustable. The two lasers are tied into one 6-mode ...
The C7A1 uses a C79 sight, which is easily distinguished by its matte black rubber overcoating. After reviewing feedback from the soldiers who used the sight, Elcan produced the fourth generation mount C79, known as the C79A2, and is mounted onto the C7A2 rifle, as well as the C8A3 carbines. The C79A2 sight is a component of the C7A2 mid-life ...
In 1995, United States Special Operations Command selected the 4×32 TA01 as the official scope for the M4 carbine and purchased 12,000 units from Trijicon. [6] Between 2004 and 2005, the TA31RCO-A4 & M4 (AN/PVQ-31A & 31B) was selected as the official Rifle Combat Optic of the United States Marine Corps , prompting Trijicon to produce 100,000 ...
The locking bar system allows for even stress to be distributed and prevent canting of the scope mount. Another form of scope canting is caused by the rings themselves. Many Weaver-type mounts, including many Picatinny-type scope rings and even the Redfield Type, have either two or four screws on top of the scope ring that hold the scope in place.