Search results
Results from the WOW.Com Content Network
Anhydrous solvents are commercially available from chemical suppliers, and are packaged in sealed containers to maintain dryness. [4] Typically anhydrous solvents will contain approximately 10 ppm of water and will increase in wetness if they are not properly stored. Organic solutions can be dried using a range of drying agents.
Anhydrous borax is sodium tetraborate proper, with formula Na 2 B 4 O 7. It can be obtained by heating any hydrate to 300 °C. [ 20 ] It has one amorphous (glassy) form and three crystalline forms – α, β, and γ, with melting points of 1015, 993 and 936 K respectively. α- Na 2 B 4 O 7 is the stable form.
A solvent is usually a liquid but can also be a solid, a gas, or a supercritical fluid. Water is a solvent for polar molecules, and the most common solvent used by living things; all the ions and proteins in a cell are dissolved in water within the cell. Major uses of solvents are in paints, paint removers, inks, and dry cleaning. [2]
TSP is used as a cleaning agent, builder, lubricant, food additive, stain remover, and degreaser. [7] As an item of commerce TSP is often partially hydrated and may range from anhydrous Na 3 PO 4 to the dodecahydrate Na 3 PO 4 ·12H 2 O. Most often it is found in white powder form. It can also be called trisodium orthophosphate or simply sodium ...
In food and beverages, glycerol serves as a humectant, solvent, and sweetener, and may help preserve foods. It is also used as filler in commercially prepared low-fat foods (e.g., cookies), and as a thickening agent in liqueurs. Glycerol and water are used to preserve certain types of plant leaves. [16]
In the laboratory, anhydrous sodium sulfate is widely used as an inert drying agent, for removing traces of water from organic solutions. [26] It is more efficient, but slower-acting, than the similar agent magnesium sulfate .
Calcium chloride was apparently discovered in the 15th century but wasn't studied properly until the 18th century. [11] It was historically called "fixed sal ammoniac" (Latin: sal ammoniacum fixum [12]) because it was synthesized during the distillation of ammonium chloride with lime and was nonvolatile (while the former appeared to sublime); in more modern times (18th-19th cc.) it was called ...
Dichloromethane is widely used as a solvent in part because it is relatively inert. It does participate in reactions with certain strong nucleophiles however. Tert-butyllithium deprotonates DCM: [20] H 2 CCl 2 + RLi → HCCl 2 Li + RH. Methyllithium reacts with methylene chloride to give chlorocarbene: [citation needed]