Search results
Results from the WOW.Com Content Network
Even though #14 and #16 screws are still available, they are not as common as sizes #0 through #12. [citation needed] Sometimes "special" diameter and pitch combinations (UNS) are used, for example a 0.619 in (15.7 mm) major diameter with 20 threads per inch. UNS threads are rarely used for bolts, but rather on nuts, tapped holes, and threaded ODs.
Thus it is today common to encounter a Whitworth hexagon which does not fit the nominally correct spanner and following the previous example, a more modern spanner may be marked 7 ⁄ 16 BS to indicate that they have a jaw size of 0.710 in and designed to take either the (later) 7 ⁄ 16 BSW or 7 ⁄ 16 BSF hexagon. [10] [11] [12]
1/4" diameter cycle thread nuts and bolts have the same 26tpi as 1/4" BSF, which means that they will fit each other in this diameter only. Traditionally the parts it would be found on are: Front axle and seat pin clamp bolt 5 ⁄ 16 inch (7.94 mm) diameter, 24 or 26 tpi threading; Rear axle 3 ⁄ 8 inch (9.53 mm) diameter, 26 tpi
Example (inch, coarse): For size 7 ⁄ 16 (this is the diameter of the intended screw in fraction form)-14 (this is the number of threads per inch; 14 is considered coarse), 0.437 in × 0.85 = 0.371 in. Therefore, a size 7 ⁄ 16 screw (7 ⁄ 16 ≈ 0.437) with 14 threads per inch (coarse) needs a tap drill with a diameter of about 0.371 inches.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
It was used for steel bolts and nuts on and in much of Britain's machinery, ... 16.75 mm: 7 ⁄ 8: 0.88 22.35 11 33.02 ... Spanner size chart
Discover the latest breaking news in the U.S. and around the world — politics, weather, entertainment, lifestyle, finance, sports and much more.
In 1913, Woolley and Meredith defined them like Anthony, but gave the following dimensions: hex head cap screws up to and including 7 ⁄ 16 inch (11.1125 mm) have a head that is 3 ⁄ 16 inch (4.7625 mm) larger than the shank diameter; screws greater than 1 ⁄ 2 inch (12.7 mm) in diameter have a head that is 1 ⁄ 4 inch (6.35 mm) larger than ...