enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Vedeneyev M14P - Wikipedia

   en.wikipedia.org/wiki/Vedeneyev_M14P

   The engine's intake system uses a gear driven supercharger and an automatic-mixture type carburetor. Power is transmitted to the propeller via a reduction gearbox. In addition to the carburetor, the engine has a speed governor, two magnetos, mechanical fuel pump, generator, and an oil pump.

3. Reciprocating engine - Wikipedia

   en.wikipedia.org/wiki/Reciprocating_engine

   Ray-traced image of a piston engine. There may be one or more pistons. Each piston is inside a cylinder, into which a gas is introduced, either already under pressure (e.g. steam engine), or heated inside the cylinder either by ignition of a fuel air mixture (internal combustion engine) or by contact with a hot heat exchanger in the cylinder (Stirling engine).

4. Inlet manifold - Wikipedia

   en.wikipedia.org/wiki/Inlet_manifold

   Carburetors used as intake runners A cutaway view of the intake of the original Fordson tractor (including the intake manifold, vaporizer, carburetor, and fuel lines). An inlet manifold or intake manifold (in American English) is the part of an internal combustion engine that supplies the fuel/air mixture to the cylinders. [1]

5. Four-stroke engine - Wikipedia

   en.wikipedia.org/wiki/Four-stroke_engine

   Four-stroke cycle used in gasoline/petrol engines: intake (1), compression (2), power (3), and exhaust (4). The right blue side is the intake port and the left brown side is the exhaust port. The cylinder wall is a thin sleeve surrounding the piston head which creates a space for the combustion of fuel and the genesis of mechanical energy.

6. Schnuerle porting - Wikipedia

   en.wikipedia.org/wiki/Schnuerle_porting

   Cylinder and ports, viewed from above. Schnuerle porting [1] [2] is a system to improve efficiency of a valveless two-stroke engine by giving better scavenging.The intake and exhaust ports cut in the cylinder wall are shaped to give a more efficient transfer of intake and exhaust gases.

7. Intake - Wikipedia

   en.wikipedia.org/wiki/Intake

   Aircraft using piston engines use intake systems similar to automobiles. With the development of jet engines and the subsequent ability of aircraft to travel at supersonic speeds, it was necessary to design inlets to provide the flow required by the engine over a wide operating envelope and to provide air with a high-pressure recovery and low distortion.

8. Manifold injection - Wikipedia

   en.wikipedia.org/wiki/Manifold_injection

   Continuously injecting mechanical MPI system Bosch K-Jetronic (ca. 1980s) The part on the right with red fuel lines coming out of it is the fuel distributor; the part on the left is a vacuum-driven piston used for determining the amount of air currently sucked into the engine

9. Naturally aspirated engine - Wikipedia

   en.wikipedia.org/wiki/Naturally_aspirated_engine

   Typical airflow in a four-stroke engine: In stroke #1, the pistons suck in (aspirate) air to the combustion chamber through the opened inlet valve.. A naturally aspirated engine, also known as a normally aspirated engine, and abbreviated to N/A or NA, is an internal combustion engine in which air intake depends solely on atmospheric pressure and does not have forced induction through a ...