Ad
related to: dorma walking beam top pivot
Search results
Results from the WOW.Com Content Network
Watt's parallel motion on a pumping engine. In previous engines built by Newcomen and Watt, the piston pulled one end of the walking beam downwards during the power stroke using a chain, and the weight of the pump pulled the other end of the beam downwards during the recovery stroke using a second chain, the alternating forces producing the rocking motion of the beam.
However, steam engines can also be classified according to cylinder technology (simple-expansion, compound, annular etc.). One can therefore find examples of engines classified under both methods. An engine can be a compound walking beam type, compound being the cylinder technology, and walking beam being the connection method. Over time, as ...
She was 282' long after her rebuild following the 1865 boiler explosion, when 30' was added to her length., [1] 35' beam (80' over the paddle guards) and 13' depth of hold, and rated at 1525 tons. She was a side-wheel steamer built entirely of wood with a single-cylinder "walking-beam" steam engine with a 57" bore and a 122" stroke. [ 2 ]
A beam engine is a type of steam engine where a pivoted overhead beam is used to apply the force from a vertical piston to a vertical connecting rod. This configuration, with the engine directly driving a pump, was first used by Thomas Newcomen around 1705 to remove water from mines in Cornwall .
The vessel was 160 ft (49 m) long, 24 ft (7 m) on the beam, with 5.7 ft (2 m) depth of hold. Her paddlewheels were 18 ft (5 m) in diameter. She had a single cylinder walking-beam steam engine, with a 17" bore and an 84" stroke. [3] The engine generated 140 horsepower, which could drive the vessel at a rate of about 12 miles per hour. [2]
In axles, the term refers to the type of suspension used on a multi-axle configurations. It is a "short axle pivoted at or near its mid-point about a horizontal axis transverse to its own centerline, normally used in pairs in conjunction with a walking beam in order to achieve two axis of oscillation."
A mother in Pennsylvania has been arrested after reportedly handcuffing her 11-year-old son to an oil tank. On Saturday, Jan. 11 at approximately 9:55 p.m. local time, the Lebanon County Regional ...
The steelyard comprises a balance beam which is suspended from a lever/pivot or fulcrum which is very close to one end of the beam. The two parts of the beam which flank the pivot are the arms. The arm from which the object to be weighed (the load) is hung is short and is located close to the pivot point.
Ad
related to: dorma walking beam top pivot