Search results
Results from the WOW.Com Content Network
1:10 scale radio-controlled car (Saab Sonett II)A radio-controlled model (or RC model) is a model that is steerable with the use of radio control (RC). All types of model vehicles have had RC systems installed in them, including ground vehicles, boats, planes, helicopters and even submarines and scale railway locomotives.
A 1:10 radio-controlled off-road buggy is a 1:10 scale radio-controlled dune buggy designed for off-road racing. These cars are based on their full-scale equivalents that are commonly found in desert racing. The buggies are split into two race categories, two (2WD) and four-wheel drive (4WD). These can easily be distinguished visually by their ...
3D flight is a type of flying in which model aircraft have a thrust-to-weight ratio of more than 1:1 (typically 1.5:1 or more), large control surfaces with extreme throws, low weight compared to other models of same size and relatively low wing loadings. Simply put, 3D flight is the art of flying a plane below its stall speed (the speed at ...
Four-stroke model engines have been made in sizes as small as 0.20 in3 (3.3 cc) for the smallest single-cylinder models, all the way up to 3.05 in3 (50 cc) for the largest size for single-cylinder units, with twin- and multi-cylinder engines on the market being as small as 10 cc for opposed-cylinder twins, while going somewhat larger in size ...
Engine size is related to the class of car; 1/10 scale on and off-road vehicles usually are equipped with .12–.18 cubic inch engines, with 1/8 scale vehicles using .21–.32 cubic inch engines. There are exceptions, with many Schumacher and Thunder Tiger/Team Associated RC models being good examples of unusually large engines coming as ...
The stationary (stator) windings of an outrunner motor are excited by conventional DC brushless motor controllers. A direct current (switched on and off at high frequency for voltage modulation) is typically passed through three or more non-adjacent windings together, and the group so energized is alternated electronically based upon rotor position feedback.
R/C versions of this engine were also produced with exhaust throttle. i.e. 1968 Cat#240-1 and the 1988 Cat#2501 with muffler/throttle. 1961 Medallion .09 & .15; The Medallion engine was also produced in (Cat#230).09 and (Cat#220) .15 cubic inch size. There were also R/C versions of these i.e. Cat#230-1 Medallion .09 RC and Cat#220-1 Medallion ...
A C6-3 motor would have between 5.01 and 10 N·s of impulse, produce 6 N average thrust, and fire an ejection charge 3 seconds after burnout. An attempt was made by motor manufacturers in 1982 to further clarify the motor code by writing the total impulse in newton-seconds before the code.