enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. T5 retrofit conversion - Wikipedia

   en.wikipedia.org/wiki/T5_retrofit_conversion

   T5 retrofit conversion can maintain existing lighting levels with the higher efficiency of the T5 lamp. However, with kits that operates the lamp on the existing magnetic ballast, the efficiency drops and the lamp life is considerably shortened, as T5 lamps aren't designed to be operated on mains frequency but only on high frequency.

3. Fluorescent-lamp formats - Wikipedia

   en.wikipedia.org/wiki/Fluorescent-lamp_formats

   Ballast-swap replacement for 2 ft T12 20 W T8 1.0, 25 3 25 F25T8 Ballast-swap replacement for 3 ft T12 30 W T8: 1.0, 25: 4: 32 F32T8: Ballast-swap replacement for 4 ft T12 40 W T8: 1.0, 25: 8: 59 F96T8: Ballast-swap replacement for 8 ft T12 75 W single-pin T12: 1.5, 38: 4 "25" F40UTSL Retrofit replacement for 4 ft T12 40 W on underpowered ...

4. Electrical ballast - Wikipedia

   en.wikipedia.org/wiki/Electrical_ballast

   [1] [3] To prevent this, fluorescent tubes are connected to the power line through a ballast. The ballast adds positive impedance (AC resistance) to the circuit to counteract the negative resistance of the tube, limiting the current. [1] Several American magnetic ballasts for fluorescent lamps. The top is a rapid start series autoregulator ...

5. GU24 lamp fitting - Wikipedia

   en.wikipedia.org/wiki/GU24_lamp_fitting

   The design was initiated by the U.S. EPA and the Lighting Research Center in 2004, in order to facilitate the deployment of compact fluorescent light bulbs with replaceable ballasts. [ 1 ] The GU24 fitting is compliant with a 2008 ruling by the California Energy Commission under Title 24 ( California Building Standards Code ) to require high ...

6. Bi-pin lamp base - Wikipedia

   en.wikipedia.org/wiki/Bi-pin_lamp_base

   The suffix after the G indicates the pin spread; the G dates to the use of Glass for the original bulbs. GU usually also indicates that the lamp provides a mechanism for physical support by the luminaire: in some cases, each pin has a short section of larger diameter at the end (sometimes described as a "peg" rather than a "pin" [2]); the socket allows the bulb to lock into place by twisting ...

7. Fluorescent lamp - Wikipedia

   en.wikipedia.org/wiki/Fluorescent_lamp

   A fluorescent lamp, or fluorescent tube, is a low-pressure mercury-vapor gas-discharge lamp that uses fluorescence to produce visible light. An electric current in the gas excites mercury vapor, to produce ultraviolet and make a phosphor coating in the lamp glow.

8. Glow switch starter - Wikipedia

   en.wikipedia.org/wiki/Glow_switch_starter

   A glow switch starter or glowbottle starter is a type of preheat starter used with a fluorescent lamp. It is commonly filled with neon gas or argon gas and typically contains a bimetallic strip and a stationary electrode. The operating principle is simple, when current is applied, the gas inside ionizes and heats a bimetallic strip which in ...

9. 3-way lamp - Wikipedia

   en.wikipedia.org/wiki/3-way_lamp

   A 3-way lamp, also known as a tri-light, is a lamp that uses a 3-way light bulb to produce three levels of light in a low-medium-high configuration. A 3-way lamp requires a 3-way bulb and socket, and a 3-way switch. In 3-way incandescent light bulbs, each of the filaments operates at full voltage. Lamp bulbs with dual carbon filaments were ...