Search results
Results from the WOW.Com Content Network
A push switch (button) is a momentary or non-latching switch which causes a temporary change in the state of an electrical circuit only while the switch is physically actuated. An automatic mechanism (i.e. a spring ) returns the switch to its default position immediately afterwards, restoring the initial circuit condition.
A switch attached to a Glock pistol. A Glock switch (sometimes called a button or a giggle switch) [1] [2] [3] is a small device that can be attached to the rear of the slide of a Glock handgun, changing the semi-automatic pistol into a selective fire machine pistol capable of fully automatic fire.
These buttons will show a graphical clue (such as staying depressed after the mouse is released) to indicate the state of the option. Such a button may be called a latch button or a latching switch. A button often displays a tooltip when a user moves the pointer over it, especially if the button's content is a standalone icon. The tooltip ...
Power On (IEC 60417-5007) and Power Off (IEC 60417-5008) symbols are used to indicate positions of the rocker switch Power button marked with Standby symbol (IEC 60417-5009) turns the device on or off without fully disconnecting power supply. A power symbol is a symbol indicating that a control activates or deactivates a particular device.
The voice switching fabric plan was similar to that of the earlier 5XB switch in being bidirectional and in using the call-back principle. [clarification needed] [citation needed] The largest full-access matrix switches (the 12A line grids had partial access) in the system, however, were 8x8 rather than 10x10 or 20x16.
A biased switch contains a mechanism that springs it into another position when released by an operator. The momentary push-button switch is a type of biased switch. The most common type is a "push-to-make" (or normally-open or NO) switch, which makes contact when the button is pressed and breaks when the button is released.
To identify the switch or switch position by which a faster than normal run (e.g. of tape) is started in the indicated direction. Fast forward: U+23E9 ⏩ #5108B Fast run; fast speed: To identify the switch or switch position by which a faster than normal run (e.g. of tape) is started in the indicated direction.
The Strowger switch has three banks of contacts. Toward the upper end of each shaft are two ratchets. The upper one has ten grooves, and raises the shaft. The lower one has long vertical teeth (on the other side, hidden). The Strowger switch uses two telegraph-type keys on a telephone set for dialing. Each key requires a separate wire to the ...