Search results
Results from the WOW.Com Content Network
TSS of a water or wastewater sample is determined by pouring a carefully measured volume of water (typically one litre; but less if the particulate density is high, or as much as two or three litres for very clean water) through a pre-weighed filter of a specified pore size, then weighing the filter again after the drying process that removes all water on the filter.
[citation needed] This information is important to help determine the structure of an unknown compound, as well as to help ascertain the structure and purity of a synthesized compound. In present-day organic chemistry, spectroscopic techniques ( NMR , both 1 H and 13 C), mass spectrometry and chromatographic procedures have replaced EA as the ...
More technically, it is a water quality parameter obtained from the loss on ignition of total suspended solids. [1] The heating of sample generally takes place in an oven at a temperature of 550 °C [1] to 600 °C. It represents the amount of volatile matter present in the undissolved solid fraction of the measured solution. VSS is an important ...
Settleable solids are measured as the visible volume accumulated at the bottom of an Imhoff cone after water has settled for one hour. [2]: 89–98 Turbidity is a measure of the light scattering ability of suspended matter in the water. [2]: 131–137 Salinity measures water density or conductivity changes caused by dissolved materials.
Total dissolved solids (TDS) is a measure of the dissolved combined content of all inorganic and organic substances present in a liquid in molecular, ionized, or micro-granular (colloidal sol) suspended form. TDS are often measured in parts per million (ppm). TDS in water can be measured using a digital meter. [1]
Gravimetric analysis describes a set of methods used in analytical chemistry for the quantitative determination of an analyte (the ion being analyzed) based on its mass. The principle of this type of analysis is that once an ion's mass has been determined as a unique compound, that known measurement can then be used to determine the same analyte's mass in a mixture, as long as the relative ...
The amine value is useful in helping determine the correct stoichiometry of a two component amine cure epoxy resin system. [6] [7] [8]It is the number of Nitrogens x 56.1 (Mwt of KOH) x 1000 (convert to milligrams) divided by molecular mass of the amine functional compound.
Suspensions are unstable from a thermodynamic point of view but can be kinetically stable over a longer period of time, which in turn can determine a suspension's shelf life. This time span needs to be measured in order to provide accurate information to the consumer and ensure the best product quality.