Search results
Results from the WOW.Com Content Network
The darcy is referenced to a mixture of unit systems. A medium with a permeability of 1 darcy permits a flow of 1 cm 3 /s of a fluid with viscosity 1 cP (1 mPa·s) under a pressure gradient of 1 atm/cm acting across an area of 1 cm 2. Typical values of permeability range as high as 100,000 darcys for gravel, to less than 0.01 microdarcy for ...
Standard cubic centimeters per minute (SCCM) is a unit used to quantify the flow rate of a fluid. 1 SCCM is identical to 1 cm³ STP /min. Another expression of it would be Nml/min. Another expression of it would be Nml/min.
A centimetre of water [1] is a unit of pressure. It may be defined as the pressure exerted by a column of water of 1 cm in height at 4 °C (temperature of maximum density) at the standard acceleration of gravity, so that 1 cmH 2 O (4°C) = 999.9720 kg/m 3 × 9.80665 m/s 2 × 1 cm = 98.063754138 Pa ≈ 98.0638 Pa, but conventionally a nominal maximum water density of 1000 kg/m 3 is used, giving ...
The pascal (Pa) or kilopascal (kPa) as a unit of pressure measurement is widely used throughout the world and has largely replaced the pounds per square inch (psi) unit, except in some countries that still use the imperial measurement system or the US customary system, including the United States.
Pressure sensors can alternatively be called pressure transducers, pressure transmitters, pressure senders, pressure indicators, piezometers and manometers, among other names. Pressure is an expression of the force required to stop a fluid from expanding, and is usually stated in terms of force per unit area.
The kayser (K) is a unit of wavenumber equal to 1 cm −1 (100 m −1). The gal (Gal) is a unit of acceleration equal to 1 cm/s 2. [3] The dyne (dyn) is a unit of force equal to 1 g⋅cm⋅s −2 (10 μN). [3] The barye (Ba) is a unit of pressure equal to 1 dyn⋅cm −2 (100 mPa). The erg (erg) is a unit of energy equal to 1 dyn⋅cm (100 nJ). [3]
The dyne per centimetre is a unit traditionally used to measure surface tension. For example, the surface tension of distilled water is 71.99 dyn/cm at 25 °C (77 °F). [4] (In SI units this is 71.99 × 10 −3 N/m or 71.99 mN/m.)
And finally, the centimetre and square centimetre are used in the normal way to measure thickness and area. The cm corresponds in the permeability equations to the thickness of the material whose permeability is being evaluated, the cm 3 STP cm −2 s −1 to the flux of gas through the material, and the cmHg to the pressure drop across the ...