Search results
Results from the WOW.Com Content Network
The French scale measures the outer diameter of the catheter, not the size of the internal drainage channel (inner diameter). For instance, a two-way catheter of 20 Fr and a three-way catheter of 20 Fr have the same outer diameter, but the three-way catheter has an additional channel for irrigation, reducing the size of its drainage channel.
It is especially popular as a unit of measurement with shooters familiar with the imperial measurement system because 1 MOA subtends a circle with a diameter of 1.047 inches (which is often rounded to just 1 inch) at 100 yards (2.66 cm at 91 m or 2.908 cm at 100 m), a traditional distance on American target ranges.
1 cm – approximate width of average fingernail; 1.2 cm – length of a bee; 1.2 cm – diameter of a die; 1.5 cm – length of a very large mosquito; 1.6 cm – length of a Jaragua Sphaero, a very small reptile; 1.7 cm – length of a Thorius arboreus, the smallest salamander [111] 2 cm – approximate width of an adult human finger; 2.54 cm ...
The 1/e 2 width is equal to the distance between the two points on the marginal distribution that are 1/e 2 = 0.135 times the maximum value. In many cases, it makes more sense to take the distance between points where the intensity falls to 1/e 2 = 0.135 times the maximum value.
Engineering fits are generally used as part of geometric dimensioning and tolerancing when a part or assembly is designed. In engineering terms, the "fit" is the clearance between two mating parts, and the size of this clearance determines whether the parts can, at one end of the spectrum, move or rotate independently from each other or, at the other end, are temporarily or permanently joined.
A degree (in full, a degree of arc, arc degree, or arcdegree), usually denoted by ° (the degree symbol), is a measurement of a plane angle in which one full rotation is 360 degrees. [4] It is not an SI unit—the SI unit of angular measure is the radian—but it is mentioned in the SI brochure as an accepted unit. [5]
It varied in size at various times and places; the Spanish unit was set at about 835.905 mm (32.91 in) in 1801. [citation needed] In Argentina, the vara measured about 866 mm (34.1 in), and typical urban lots are 8.66 m (28.41 ft) wide (10 Argentine varas). At some time a value of 33 inches (838.2 mm) was adopted in California. [citation needed]
Centimeters (cm) are avoided as they cause confusion when reading plans. For example, the length two and a half meters is usually recorded as 2500 mm or 2.5 m; it would be considered non-standard to record this length as 250 cm. [12] [13]