Search results
Results from the WOW.Com Content Network
This is called a "dual trace" oscilloscope. The switch worked to display 2 or 4 separate electrical signals on the screen. This required little duplication and added only a small amount to the cost. This is the technique used in all the dual and four-trace plug-ins such as the CA, 1A1, 1A2, Type M and 1A4.
It can be an external input, one of the vertical channels of a dual or multiple-trace oscilloscope, or the AC line (mains) frequency. Another switch enables or disables auto trigger mode, or selects single sweep, if provided in the oscilloscope. Either a spring-return switch position or a pushbutton arms single sweeps.
A dual-beam oscilloscope was a type of oscilloscope once used to compare one signal with another. There were two beams produced in a special type of CRT . Unlike an ordinary "dual-trace" oscilloscope (which time-shared a single electron beam, thus losing about 50% of each signal), a dual-beam oscilloscope simultaneously produced two separate ...
TRADE NEWS: Agilent Technologies' New 2- to 16-Channel 60-GHz Oscilloscope System Reduces Cost of Te. BusinessWirevia The Motley Fool. Updated July 14, 2016 at 9:38 PM.
In microelectronics, a dual in-line package (DIP or DIL) [1] is an electronic component package with a rectangular housing and two parallel rows of electrical connecting pins. The package may be through-hole mounted to a printed circuit board (PCB) or inserted in a socket.
A Tektronix TDS210 digital oscilloscope. A digital storage oscilloscope (DSO) is an oscilloscope which stores and analyses the input signal digitally rather than using analog techniques. It is now the most common type of oscilloscope in use because of the advanced trigger, storage, display and measurement features which it typically provides. [1]
A passive oscilloscope probe with a switch in the probe handle that selects 1× or 10× attenuation To minimize loading, attenuator probes (e.g., 10× probes) are used. A typical probe uses a 9 megohm series resistor shunted by a low-value capacitor to make an RC compensated divider with the cable capacitance and scope input.
Time-division multiplexing (TDM) is a method of transmitting and receiving independent signals over a common signal path by means of synchronized switches at each end of the transmission line so that each signal appears on the line only a fraction of time according to agreed rules, e.g. with each transmitter working in turn.