Search results
Results from the WOW.Com Content Network
This is called a "dual trace" oscilloscope. The switch worked to display 2 or 4 separate electrical signals on the screen. This required little duplication and added only a small amount to the cost. This is the technique used in all the dual and four-trace plug-ins such as the CA, 1A1, 1A2, Type M and 1A4.
Dual-trace oscilloscopes have a mode switch to select either channel alone, both channels, or (in some) an X‑Y display, which uses the second channel for X deflection. When both channels are displayed, the type of channel switching can be selected on some oscilloscopes; on others, the type depends upon timebase setting.
A dual-beam oscilloscope was a type of oscilloscope once used to compare one signal with another. There were two beams produced in a special type of CRT . Unlike an ordinary "dual-trace" oscilloscope (which time-shared a single electron beam, thus losing about 50% of each signal), a dual-beam oscilloscope simultaneously produced two separate ...
The article TRADE NEWS: Agilent Technologies' New 2- to 16-Channel 60-GHz Oscilloscope System Reduces Cost of Testing High-Speed Designs originally appeared on Fool.com. Try any of our Foolish ...
A Tektronix TDS210 digital oscilloscope. A digital storage oscilloscope (DSO) is an oscilloscope which stores and analyses the input signal digitally rather than using analog techniques. It is now the most common type of oscilloscope in use because of the advanced trigger, storage, display and measurement features which it typically provides. [1]
The BK Precision model 4078 Dual Channel Arbitrary Waveform Generator uses direct digital synthesis to generate waveforms up to 400,000 points HAMEG HMF 2550 digital AWG under an oscilloscope displaying the generated waveform. An arbitrary waveform generator (AWG) is a piece of electronic test equipment used to generate electrical waveforms.
An oscilloscope generally receives three channels of varying (or oscillating) voltage as input and displays this information on a cathode ray tube. The oscilloscope amplifies the input voltages and sends them into two deflection magnets and to the electron gun producing a spot on the screen. One magnet displaces the spot horizontally, the other ...
These modules switch the power using an impulse relay. In the U.S., these modules are generally rated to control loads up to 15 amperes (1800 watts at 120 V). Many device modules offer a feature called local control. If the module is switched off, operating the power switch on the lamp or appliance will cause the module to turn on.