Search results
Results from the WOW.Com Content Network
An empty fire extinguisher which was not replaced for years. Most countries in the world require regular fire extinguisher maintenance by a competent person to operate safely and effectively, as part of fire safety legislation. Lack of maintenance can lead to an extinguisher not discharging when required, or rupturing when pressurized.
A standard APW extinguisher in the United States contains 9.5 litres (2.5 US gal) of water in a stainless steel tank. The water is discharged by means of a 13 mm (1 ⁄ 2 in) hose, with a smooth-bore nozzle attached to the tip. They will initially produce a 12–15 m (40–50 ft) stream of water, with a discharge time of about 50 seconds.
Dry chemical powder is used on all classes of fires. Dry chemical powder puts out the fire by coating the burning material with a thin layer of dust, thereby separating the fuel from the oxygen in the air. The powder also works to interrupt the chemical reaction of fire, so these extinguishers are extremely effective at putting out the fire.
In other words, a fast flow extinguisher expels a higher volume of agent in less time than a standard compliance flow extinguisher. As a result, fast flow extinguishers have lower UL class A&B ratings than compliance flow extinguishers (the class B numerical rating is the approximate square feet of burning fuel a novice operator could expect to ...
A fire sprinkler system is an active fire protection method, consisting of a water supply system providing adequate pressure and flowrate to a water distribution piping system, to which fire sprinklers are connected. Although initially used only in factories and large commercial buildings, systems for homes and small buildings are now available ...
This would produce flow rates from a typical 1-3/4" inch hose of 120 US gal (450 L) per minute of foam solution and 60 cu ft (1.7 m 3) per minute of compressed air. This air to foam solution ratio produces a wet, quick draining finished foam that will quickly knockdown flame and reduce fire compartment temperature.
In fire protection engineering, the K-factor formula is used to calculate the volumetric flow rate from a nozzle. Spray nozzles can for example be fire sprinklers or water mist nozzles, hose reel nozzles, water monitors and deluge fire system nozzles.
The hot aerosol fire suppression technology went through several generations: gen I (oil tank suppression system) and gen II (potassium nitrate-based, efficient but with corrosive byproducts) denoted as K-type systems, then gen III (boosted strontium salt-based, less deliquescent and generating less corrosive byproducts) denoted as S-type systems.